作者简介吴晓（1965-）,男,湖南常德人,教授,主要从.PDFVIP

作者简介：吴晓(1965-) ，男，湖南常德人，教授，主要从事工程力学研究。湖南省科技计划项目资助(批准号：湘财企指[2011]65 号)，湖南“十二五” 重点建设学科项目资助 (E-mail: wx2005220@163.com) 均匀内压作用下双模量简支扁壳的非线性弯曲 吴晓 孙晋 (湖南文理学院 415000 常德) 摘要: 双模量扁壳在均匀内压作用下，会形成拉压弹性模量不同的各向同性拉伸区和压缩区，把双模量扁 壳看成两种材料组成的层合扁壳，采用板壳理论求得了双模量扁壳在均匀内压作用下中性面位置，推导出 了双模量扁壳挠度与均匀内压的关系式，并把该方法的计算结果与有限元方法计算结果进行了比较，验证 了该计算方法的可靠性。算例分析表明,当拉压弹性模量相差较大时，将双模量材料作为单模量材料计算时, 其中误差绝对值最小值为24.4% ，误差绝对值最大值为35.38% 。因此，均匀内压作用下双模量简支扁壳的 大挠度弯曲计算必须考虑双模量材料拉压弹性模量不同的特性。 关键词: 均匀内压；双模量；扁壳；大挠度；弯曲 中图分类号: O343.7 文献标志码: A 文章编号: Large Deflection Analysis of Bimodulous Flat Shell Under Uniform Inner Pressure Wu Xiao , SUN Jin (Hunan University of Arts and Science, Changde 415000) Abstract: Bimodulous flat shell can form isotropic compression and tensile area under loads. Bimodulous flat shells is regarded as laminated plate composited of two kinds of otropic material. The location of neutral plane in bimodulous flat shell is determined by the utilization of the theory of plates and shells. Then the deflection equtions of bimodulous flat shell under uniform inner pressure are got. Meanwhile the calculated results of this method are compared with the finite element method, which verify the reliability of the calculation method. The example analysis shows when there is larger difference between tensile elastic modulus and compressive elastic modulus and the bimodulous material is calculated as single-modulus, the minimum absolute error is 24.4% and the maximum absolute error is 35.38%. Therefore, the large deflection calculation of flat shell in the uniform internal pressure must consider different characteristics of bimodulous material between tensile elastic modulus and compressive