在虚拟化平台上运行关键的应用U2VL.pptx

;内容提要;什么是关键应用 ?;100%;这些坚定的从 Unix 移植到 Vmware-Linux 的企业都同时看到了什麽？;Agenda;X86-E7-ESX 性能 优于 Power6 21% ;XX保险公司 Oracle OLTP 在线交易 – 虚拟化最终测试结果;惨;踏破铁鞋：X86 服务器与 Power7小机 TPC-C的比较;每个核的性能 Power7 比 虚拟化后的x86 快 12% Vmware 数据库虚拟化后的损耗为5.8% ;VMware+x86Linux与 PowerVM-AIX的性能比较;性能我清楚了，不用再测了。接着我们看HA的测试结果，如果可以，我们可以开始规划一步一步的把小机换成x86;;Step 1. Install the PowerHA softwareYou can purchase this software from IBM directly (see Resources for a link); the file sets all start with the word cluster. Use the installp command to install the software, much like any other licensed program package (LPP).Step 2. Edit some flat filesPut all of the IP addresses associated with the cluster—boot, persistent, and service—into each /etc/hosts file on each node of the cluster. Do the same with the /usr/es/sbin/cluster/etc/rhosts file. Verify that the server hostnames match the appropriate IP addresses; the servers hostname should also match with the persistent IP address.Step 3. Configure the boot IP addressesRun the smitty chinet command, and set the boot IP addresses for each network adapter. Make sure that you are able to ping and connect freely from node to node on all respective networks. Also, double-check to make sure that the default route is properly configured. If it isnt, run smitty tcpip, go into the Minimum Configuration menu, enter the default route for the primary adapter, and press Enter.Step 4. Make application start and stop scriptsCreate two simple Korn shell scripts—one that starts an application and one that stops an application. Keep these scripts in identical directories on both nodes.Step 5. Define the clusterRun the command:smitty cm_config_an_hacmp_cluster_menu_dmn Then, define the cluster, including naming it appropriately.Step 6. Define the nodesRun the command:smitty cm_config_hacmp_nodes_menu_dmn Define every node within the cluster on both nodes.Step 7. Define the networksRun the command:smitty cm_config_hacmp_networks_menu_dmn This defines one network per Ethernet adapter. I