变频器设计需要知道地电机电缆知识.pptVIP

4.2 wiring of armored cable For armored cable is similar with shield non-armored cable ,except it need to be correctly terminated with metal gland, so in this clause we just talk about its termination 4.2.1.wiring of armored cable Picture of gland kit and assemble gland parts on the cable Continued Stripping jacket and cut amour Continued Stripping insulation Continued Fitting gland cone section Continued Sealing the back of gland and connect to enclosure 4.3. wiring of non-armored cable (shield cable ) Difference between with conduit and without conduit as connection to terminal is that :shield cable or armored cable need fix shield issue , as left picture show , you need twisted into pigtail and connect it to ground, and don’t need fix conduit issue 5. Terminal block Content : Major characters of Terminal Current carrying capability of cables Ring tongue and fork terminal of cable 5.1. Major characters of Terminal block Rated voltage Current carrying capability Cable size carrying capability ,depending on cable terminal Structure of terminal block , cage or screw To be continued 5.2. Current carrying capability of cables Placing current carrying capability here is because I’d like to introduce not only motor cable but including inner cables we used in drive To be continued 5.3. Ring tongue and fork plugs of cable To be continued 6. Conduit introduction Please refer to the attached file to see more information. it was made by WIKI Content In the chapter, we just introduce these components are relevant to rigid metal conduit (RMC) and close to drive design. They are suppose to be nipple , knock nut, connector, busing and elbow, some others like clamp ,strap and service entrance etc, is not included 1. video 2. component introduction 3. how to design conduit box , length of conduit , diameter of conduit hole and others 6.1. video Halex is a cabling relevant component vendor, it puts video on its website to explain how t