可编程控制器在工业中的应用 毕业论文文献翻译 中英文对照.docVIP

原文 Microcomputer numerical control system commonly used connection 1、Input device connection On the CNC numerical control engine bed often provides the input device has the tape reader, the manual data feeds/CRT monitor, magnetic tape unit, magnetic disk unit and its corresponding connection. What is most commonly used is the tape reader and the manual data feeds (keyboard). 1)、 Tape reader connection The CNC installment uses 8 units tape readers, according to the photoelectricity transformation principle, (has the paper tape recording information hole or non condition) transforms the corresponding electrical signal, sends in the CNC installment after processing. The tape reader connection electric circuit by the hole signal accepting circuit, the paper takes into for the control circuit as well as walks the belt and the reel control circuit and so on is composed. The hole signal accepts the electric circuit light emitter diode to take the luminophor, the photosensitive triode takes the light signal acceptor. After the paper tape 8 signals transfer the electrical signal, sends in the paper tape data register to check, the paper tape synchronized hole signal forms the electric circuit after the pulse to form a pulse, delivers the interrupt request trigger, sends out the interrupt request to CPU, if CPU responds this severance, then accepts the memory from the data register 8 signals. The paper takes into for the control circuit accepts comes from the CPU control command, the actuation corresponding electro-magnet, causes the paper tape to, to be reverse or to stop the belt. Walks the belt and the reel control circuit accepts comes from the CPU control command, the actuation to or reverse walks the charged motive. The reel work way transforms, three positions by a three position controls switch into the release, puts through with the separation. Is releasing the position to relax the paper tape, in order to loading and unloading paper tape; Is puttin