同昌闸泵建工程初步设计.docVIP

PAGE \* MERGEFORMAT I 1 中 文 摘 要 同昌水闸、泵站重建工程位于珠海市香洲区南屏镇同昌村，石豆涌（也称挂锭角排洪渠）下游，珠海大道南侧，南屏镇西侧约10km处，水闸、泵站出口与广昌涌连通，原有水闸已不能满足排涝需求，因此重建。 泵站设计流量为6.168m3/s，设计扬程1.502m，最大扬程2.561m，,选用3台潜水轴流泵（800QZ－135），单台泵工况为：叶片安装角为+4°， Q=2.12m3/s，H＝3.2m，n=590r/min，效率η=81.7%，配套轴功率81.5KW，电机容量132KW，总装机容量244.5 KW。水泵采用混凝土制井筒悬吊式安装，主要建筑物包括泵房、隔墩、进水池、出水池、后墙，主厂房，副厂房等，设计内容包括水泵的选型，主要建筑物设计，稳定计算，结构计算等。 水闸设2孔，每孔净宽3m，总净宽6m，开敞式闸室，钢筋混凝土结构，闸室顺水流方向长5m，垂直水流方向宽7.8m，本次设计包括水闸尺寸的计算、消力池的计算、防渗的计算、稳定计算、结构计算以及配筋计算。 该水闸、泵站的兴建，将对抗旱灌溉及防洪排涝发挥重要作用。 关键词： 水闸 泵站 堤防 稳定计算 结构计算  Preliminary design of Tongchang gate station Song Wensheng College of Water conservancy and Civil engineering, South China Agricultural University， Guangzhou 510642，China ABSTRACT：Tongchang sluices and pumping station reconstruction project is located in zhuhai xiangzhou district has injected with chang village nanping town, Stone bean chung hang (also called spindle Angle having canal) downstream, Zhuhai avenue south, Nanping town west side about 10 km, Connect to GuangChang chung sluices, pumping station exit, Original sluices can not meet the demand of draining, so rebuilding. The pump station design flow of 6.168m3 / s, design head 1.502m, the maximum head 2.561m. Use 800QZ－135Vertical axial flow pump,a single pump working condition is: the blade installation angle of + 4 °, Q=2.12m3/s，H＝3.2m，n=590r/min，The efficiency of η = 81.7%, supporting shaft power 81.5 KW, the motor capacity of 132 KW, the total installed capacity of 244.5 KW. Pump by concrete shaft suspension type installation, main buildings include pump room, lie between block, into the pool, the pool and back wall. Main workshop, deputy factory building, etc., design contents include the selection of pump, the main structure design, stability calculation, structure calculation, etc. Lock set 2 holes, each hole width of 3 m, the total width of 6 m, open type chamber, reinforced concrete structure, the lock chamber at the flow direction of 5 m long, 7.8 m wide, vertical flow direc