毕业论文(设计)-《军绿色ABS注塑制品生产工艺探讨》.docVIP

PAGE 河　南　科　技　学　院 本科毕业论文 论文题目：军绿色ABS注塑制品生产工艺探讨 学生姓名: 所在院系： 化学化工学院 所学专业： 化学工程与工艺 导师姓名： 完成时间： 年5月30日 摘 要 通过寻找ABS军绿色注塑制品的最佳配方，优化注塑工艺参数，对注塑制品生产工艺进行了设计和探索。根据染色的基本理论，确定了ABS军绿色注塑制品的染色配比，找到了各染色组分对颜色的影响。结合典型实例，对ABS军绿色注塑制品的生产工艺进行了设计和工艺优化，找到了制品颜色差别的原因，并提出了相应的解决方法。 怎样把ABS树脂染成军绿色并且了解它的工艺过程和研究这种军绿色染料的最佳配比及它在生产过程中最佳工艺参数是多少。根据颜料的基本三色配比，在不断比例调节下使颜色达到自己所要配的颜色，然后用ABS树脂原材料和一种润滑剂充分混合后加入配比均匀的军绿色染料使它们再进行充分混合后看看是不是能够着色,如果能又如何让它干燥,在各个研究环节中找出最佳参数。 关键词：ABS塑料、军绿色、着色、注塑成型 Discussion For Technology Of Breen ABS Injection Molding Products Yang Yuan-dong School of Chemistry and Chemical Engineering, Henan Institute of Science and Technology Abstract Through seeks the ABS armed force green to cast the product the best formula, the optimization casts the craft parameter, to cast the product production craft to carry on the design and the exploration. According to elementary theory which dyes, had determined the ABS armed force green casts product the dyeing allocated proportion, had found each dyeing component to the color the influence. The union typical example, cast the product to the ABS armed force green the production craft to carry on the design and the craft optimizes, had found the product color difference reason, and proposed the corresponding solution. How ABS resin eldest Army green and understand the process and the study of this army of green dye and its best ratio in the production process is the best process parameters number. According to the basic paint color ratio, the ratio of constantly makes adjustments to their colors to the color，Then ABS resin raw materials and a full lubricant mixing ratio to the military uniform green dye so that they again After mixing is not to look at color，If how it dry in all aspects of research to find the best parameters. Keywords : The ABS plastic, the armed force green, the coloration, injection molding technology PAGE 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc169710380 1 引言 PAGEREF _Toc1697