NOKIA生产过程控制全球培训课程教材（三）.PPTVIP

Cp and Cpk Indices and Defects(both tails of the normal distribution) The Effects of Cpk and Cp on FFR Exercise 2: Cp and Cpk Calculate Cp and Cpk for the 100 measurements in the file Data exercise 1.xls Determine the approximate Cp and Cpk for the 4 sample populations on the following page Should actions be made to improve these processes. If yes, which? Estimate Cp and Cpk? Estimate Cp and Cpk? - A) Estimate Cp and Cpk? - B) Estimate Cp and Cpk? - C) Estimate Cp and Cpk? - D 1. Run in and stabilise process 2. Note the main parameters for reference 3. When the process is stable run the tool for 10 hours 3. Take 5 parts out from each cavity every half hour and mark them with time, date and cavity. Total 20 sets of 5 parts from each cavity must be made, or according to agreement. Exercise 3: Cpk Data Spreadsheet Open spreadsheet Data exercice 3.xls. Dim 13 is identical to the data from the previous exercises. Verify the results from the previous exercises for dimension 13. Analyse the remaining data sets an comment the process, should any actions be made? Remember to create and look at the charts. Section 5.Confidence of Cpk Confidence of Cpk Cpk values are not definite numbers as they are based on relatively small samples of a population. The 95% confidence interval determines the interval which includes the true Cpk value with a probability of 95%, i.e. there is a probability of 5% that Cpk is either lower or higher than this confidence interval. Confidence of Cpk Cpk Confidence Limits with a sample size of 100 and a nominal Cpk of 1.67 This shows the area of the data entry sheet where the statistical analysis is displayed. This is the DMM00024 presentation of the histogram and normal distribution curve Also the design tolerance area is indicated by the heavy line on the x-axis Check the histogram and look for the normal distribution shape with no outliers or obvious multi-modal nature. NOTE: The spreadsheet makes no statistical check of normality.