德马格真空泵行车原理操作培训讲义vacm ifter.ppt

8. Core detection emergency stop - adjustment paper reel x+ / x- / y + / y-detection range : approx. 150 mm Emergency stop detection range : approx. 100 mm 8. Core detection emergency stop - adjustment 9. Slack rope detection slack rope detection 10. Core dumping detection top botton inner core diameter : 76 and100 mm 10. Core dumping detection top botton top botton top botton inner core diameter: 76 mm inner core diameter: 100 mm top botton top botton inner core diameter: 60 mm inner core diameter: 113 mm Failure Failure 11. Reference plate 12. Maintenance vacuum lifter MAINTENANCE Before starting maintenance always switch-off and disconnect the machine. Maintenance is only to be done by skilled personnel, especially maintenance on the electrical circuit. When you remove protections, covers etc. for maintenance, do not start the machine before these are mounted again. 11. Maintenance vacuum lifter The following service intervals are based on working three shift per day. After 40 hours - In order to prevent damage on the Aerolift and for the safety of your machine, fasten all the bolts after the first 40 working hours. 11. Maintenance vacuum lifter 4.2. Every 170 hours (weekly) Check the oil level of the vacuum pump. Before doing this, stop the pump for at least 10 minutes. The oil level glasses are situated at the side of the pump. Oil can be filled after removing the filling plug. For more details on and a general drawing of the vacuum pump, see “Instruction manual vacuum pump”. Check the vacuum hoses (pos. 16). When the hoses are damaged or when they are over 70% unround, they should be replaced. Care for proper fastening of the hose-clamps. - Check the rubber seals, see maintenance drawing (pos. 14). If they are in bad condition and do not seal properly anymore, they have to be replaced. The old seal can be pulled from the profile (pos. 68) and the new ones can be pushed into t