generic specification for high performance …s5vypcce.docVIP

Generic Specification For High Performance Revenue Power Meter with Power Quality Recording Functionality: Nexus 1260 1. PRODUCT 1.1 Power Meters A. Power meter shall be multi-function 3 phase, solid-state, socket-mount design. 1. Meter shall be capable of connection to three-phase, four-wire or three-phase, three-wire circuits. 2. Meter shall support meter form factors 9S, 36S, 45S and SWB Form Rated Voltage Type 9S 120 to 277V L-N 3E, 4W, Wye 36S 120 to 277V L-N 2 ? E, 4W, Wye w/ Neutral 45S 120 to 480V L-L 2E, 3W, Delta SWB 120 to 277V L-N Programmable B. Voltage and current inputs to the meter shall conform to the following at a minimum: 1. Meter shall be a Class 20, transformer rated design. The unit will monitor up to 22 amps continuously. 2. Monitor shall accept input of three (3) independent voltage inputs and three (3) independent current inputs of the stated capacity. 3. Voltage inputs shall be rated for connection to circuits from 0 to 277 volts AC line-to-neutral or 0 to 480 volts AC line-to-line and shall be auto-ranging over this range. 4. Voltage input shall be optically isolated to 2500 volts DC. Shall meet or exceed IEEE 37.90.1 (Surge Withstand Capability) 5. Current inputs shall have a continuous rating of 110% of Class Current and a 1-second over-current rating of 500 %. C. Power meter shall measure and report the following quantities at a minimum: 1. Voltage, both phase to neutral and phase to phase, for all three phases; Phase angles for each voltage relative to each other. One cycle, 100 millisecond and one-second readings shall be available simultaneously. Current, phase A, B, C, and N-calculated; Phase angles for each current relative to voltages. One cycle, 100 millisecond and one-second readings shall be available simultaneously. \ 3. Watts (total and per phase), VARs (total and per phase), VA (total and per phase), Power Factor (total and per phase) and Frequency. 100 millisecond and one second readings shall be available