单独检测核时出现的错误.DOCVIP

单独检测核时出现的错误 Error connecting to the target: (Error -1143 @ 0x0) Device core was hung. The debugger has forced the device to a ready state and recovered debug control, but your applications state is now corrupt. You should have limited access to memory and registers, but you may need to reset the device to debug further. (Emulation package 5.0.872.0) C66xx_0: Error connecting to the target: (Error -1143 @ 0x0) Device core was hung. The debugger has forced the device to a ready state and recovered debug control, but your applications state is now corrupt. You should have limited access to memory and registers, but you may need to reset the device to debug further. (Emulation package 5.0.872.0) IcePick_D: Power Failure on Target CPU IcePick_D: Failed to remove the debug state from the target before disconnecting. There may still be breakpoint op-codes embedded in program memory. It is recommended that you reset the emulator before you connect and reload your program before you continue debugging C66xx_0: Error connecting to the target: Connect to PRSC failed 用JTAG链接DSP开发板时，提示的信息如下 [Start] Execute the command: %ccs_base%/common/uscif/dbgjtag.exe -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity [Result] -----[Print the board config pathname(s)]------------------------------------ C:\DOCUME~1\ADMINI~1\LOCALS~1\APPLIC~1\.TI\ 4084209646\0\0\BrdDat\testBoard.dat -----[Print the reset-command software log-file]----------------------------- This utility has selected a 560/2xx-class product. This utility will load the program sd560v2u.out. The library build date was Oct 3 2012. The library build time was 22:14:17. The library package version is 5.0.872.0. The library component version is 35.34.40.0. The controller does not use a programmable FPGA. The controller has a version number of 5 (0. The controller has an insertion length of 0 (0. The cable+pod has a version number of 8 (0. The cable+pod has a capability n