联想笔记本拆机导图9wdelb6g.pptVIP

Pull out the adapter cable. The correct arrowhead instruct should be followed. M/B Remove Procedure-3 Parts Remove-LCD RAM Battery Wireless HDD CPU FAN LCD M/B TOP Keyboard ODD Disassembly the hinge screws firstly as left label shown. LCD Remove Procedure-1 6# 6# Disassembly the screws one by one as the left label shown. LCD Remove Procedure-2 6# 6# 6# 6# Pick the protection sponge one by one firstly, as left label shown. LCD Remove Procedure-4 Disassembly the screws one by one as left picture shown. LCD Remove Procedure-5 4# 4# 4# 4# 4# 4# Pull out the LCD bezel by hands carefully. The arrowhead instruct was recommended LCD Remove Procedure-6 Step 1: Pull out the camera cable firstly as left label shown; Step 2: Pull out the inverter cable on its two sides, the instruct arrowheads were shown. LCD Remove Procedure-7 Disassembly the screws one by one as left picture shown. LCD Remove Procedure-8 2# 2# 2# 2# 2# 2# Pull out the LCD cable smoothly as the label shown. LCD Remove Procedure-9 Disassembly the screws as left picture shown. Through this operation, LCD bracket can be removed. LCD Remove Procedure-10 2# 2# Screw Define There are total six kinds of screw for TianYi Y310 series using. It will show the size number in the following chapters, which were relate to the screw size labels defined as shown as above photo. 6# 5# 4# 3# 2# 1# Parts Remove-Battery RAM Battery Wireless HDD CPU FAN LCD M/B TOP Keyboard ODD Step 1: Push the latch to left as label 1 shown; Step 2: Push the latch to right as label 2 shown; Step 3: Pull the battery out of case as label 3 shown. Note: The system Battery/Adapter should be removed firstly and install at the last step for any spare part disassembly operation! Battery Remove Procedure 1 2 3 Parts Remove-Battery Battery Wireless HDD CPU FAN LCD M/B TOP Keyboard ODD RAM Step 1: Tweak the screws as label shown one by one; Step 2: Then pick the CPU cover