毕业论文（设计）长平二矿2.40Mt-a新井设计.docVIP

PAGE II PAGE I 摘要 长平二矿拥有四层可采煤层，煤层和煤厚分别是1(2)、2(2.5)、3(5.5)。煤层南北走向约为3500m，东西倾向约为5000m，井田面积约为17.64 km2。平均倾角为6度。工业储量为2.47亿吨，设计储量为2.17亿吨，可采储量为1.70亿吨。本设计从矿井的开拓、开采、运输、通风、提升及工作面的采煤方法等各个环节进行了详细的叙述，设计严格遵守《设计规范》和《煤矿安全规程》，整个矿井采用了先进的皮带运输，提高了运输能力，为矿井的增产打下了良好的运输基础。采煤方法采用走向长壁综合机械化采煤方法。工作面支护方式为液压支架支护方式，端头支护采用端头支架。本设计采用立井单水平大巷布置，主井采用箕斗提升，副井采用罐笼提升，大巷采用集中布置。通风方式为中央并列式。本次设计是长平二矿新井设计，地质资料都是在实习矿上搜集的，在指导教师的指导下，并合理运用平时及课堂上积累的知识，查找有关资料和文献，力求设计出一个高产、高效、安全的现代化矿井。 关键词：煤矿开采；开拓布置；运输；开采方式；通风 Abstract Chang ping II coal mine can have a four-layer thick coal seam, and were 1 (1), 2 (2.5) ,3 (5.5). Coal from north to south is about 3500m, things tend to about 5000m, Ida area of approximately 17.64 km2. Angle of 6 degrees. Reserves of 247 million tons of industrial design reserves of 217 million tons, recoverable reserves of 170 million tons. This design from the mine exploration, mining, transport, ventilation, and face to enhance all aspects of mining methods described in detail, rigorously designed to comply with the Design Standards and Coal Mine Safety Regulations, the mine employs advanced belt transport, increased transport capacity for the mines output has laid a good transport infrastructure. Mining Methods trendency mechanized longwall mining method. Face support means for the hydraulic support means end support with end support. This design uses a lang one level, the main shaft with skip hoisting, with cage hoisting shaft, roadway layout with focus. Ventilation for the central abreast ventilation. The mine design is Chang ping two new well design and geological data are collected by the mine in the practice, under the guidance of teachers in guidance and ordinary and reasonable use of the knowledge gained in class, find the relevant information and documentation, and strive to design a high , efficient, modern coal mine safety. Key words: Coal mining; Development arrangement; Transport; Mining methods;