韩国灯具标准_附件.docVIP

*@Korean National Standards@* CHAPTER 3 (usual structure) 常用结构 ?1. The rise in temperature in The Exit lamp must not make trouble 标志灯内部温度升高不能影响其在使用市电时的功能。 or do harm against it’s ability within using power sauce(常用電壓) and voltage. ? 2.Anti-explosion structure of Anti-explosion Exit lamp must meet standards arranged by Korean industrial standard of Industrial safety law. 防爆型标志灯的结构要符合韩国行业安全法的行业标准。? 3.Set up the Fuse which can protect main power sauce and emergent power sauce from short-circuit. But, Exit lamp being used in seat in a theater(客席lamp) is exceptional. 必须安装保险丝以保证市电以及应急电源在短路时获得保护。? 4.The outer cover of Exit lamp must not be transformed or be changed color through rise-heat. 标志灯外壳在温度升高时不得变色。? 5. The outer surface of Exit should be disassembled easily, battery and inner spare parts also should be replaced, repaired and inspected easily. But, water-proof and anti-explosion ones are exceptional. 标志灯外壳必须容易拆卸，电池和内部零件必须容易更换、修理和检视。但是防水及防爆灯例外。 6.When lighting sauce or lighting tube being changed and inspected, Exit lamp’s contacting parts should be protected not as to get an electronic shock. 标志灯的连接件安放妥当，以防在更换或检视光源或灯管时发生电击. ? 7.Using power voltage(使用電壓) should be 2V~300V. But, in case it’s charging parts not exposed, available exceeed 300V 适用电压为2V—300V, ? 8.It’s structure should be made strong for establishment place. 标志灯的结构强度必须能够承受安装环境。? 9.It’s structure should be made not getting obstacles itself ability from vibration or shock on transportation. 标志灯的结构要能承受运输过程中的振动和冲击。? 10.The inner temperature of exit lamp should not be risen abnormally, Battery and inner parts have to be in heat-proof management 标志灯的内部温度不能发生非正常升高的情况，电池以及内部零部件要有过热保护装置? 11.Distributing wires配線) should not be soldered directly to the battery.  导线不能直接焊在电池上。 ? 12.The power sauce which connecting with using power sauce should be fit for standard fiber insulation drawing wire and vinyl code. 连接电源的电线必须符合导线和包皮物料的标准 13.The thickness : Drawing wire(引出線)=size: over 0.75m2 other