SHT30中文资料.pdfVIP

SHT30 温湿度传感器部分翻译资料 3 Pin Assignment 3、引脚分配 The SHT3x-DIS comes in a tiny 8-pin DFN package see Table 6. SHT3x-DIS 是一个8 位的DFN 小包，见表6 3.1 Power Pins (VDD, VSS) 3.1、电源引脚 （VDD, VSS ） The electrical specifications of the SHT3x-DIS are shown in Table 3. The power supply pins must be decoupled with a 100 nF capacitor that shall be placed as close to the sensor as possible – see Figure 11 for a typical application circuit. SHT3x-DIS 的电气参数如表3 所示。电源引脚必须与一个 100nF 的电容器尽可能地隔离， 以便尽可能靠近传感器——请参见典型应用电路图11。 3.2 Serial Clock and Serial Data (SCL, SDA) 3.2、串行时钟和串行数据（SCL，SDA） SCL is used to synchronize the communication between microcontroller and the sensor. The clock frequency can be freely chosen between 0 to 1000 kHz. Commands with clock stretching 11 according to I2C Standard are supported. SCL 用于同步微控制器和传感器之间的通信。时钟频率可以在0 到1000 千赫之间自由选择。 11 支持按I2C 标准 进行时钟扩展的命令。 The SDA pin is used to transfer data to and from the sensor. Communication with frequencies up 11 to 400 kHz must meet the I2C Fast Mode standard. Communication frequencies up to 1 Mhz are supported following the specifications given in Table 20. SDA 引脚用于向传感器传递数据和从传感器传递数据。频率高达400 kHz 的通信必须满足 11 I2C 快速模式 标准。根据表20 给出的规格，支持1 兆赫的通信频率。 Both SCL and SDA lines are open-drain I/Os with diodes to VDD and VSS. They should be connected to external pull-up resistors (please refer to Figure 11). A device on the I2C bus must only drive a line to ground. The external pull-up resistors (e.g. Rp =10 kΩ) are required to pull the signal high. For dimensioning resistor sizes please take bus capacity and communication 11 frequency into account (see for example Section 7.1 of NXPs I2C Manual for more details ). It should b