毕业论文落料拉深复合模设计.docVIP

摘 要 在工业生产中冲压成形技术应用是很广泛的，板料冲压技术是金属加工的一种基本方法，它主要用于生产各种板料零件，具有生产效率高、重量轻、尺寸精度好、低成本并且容易实现机械化和自动化等特点。本文针对筒形零件的落料工艺性和拉深工艺性，将其设计为落料拉深复合模。 其设计说明中包括了冲压件的工艺性分析、工艺方案的拟定、排样设计、拉深次数、模具结构形式的合理性分析、及模具工作尺寸的计算、冲压设备的选择。对于落料拉深复合模来说，成形凸凹模的设计也较重要。为了设计的合理化，尽可能选用了标准件，如模座，模架，导柱导套等。该论文中也对非标准的零件结构设计，并且附有相应的零件图，最后根据零件结构设计和生产零件的要求生成了总装配图。 关键词：复合模； 落料； 拉深； 装配图 ABSTRACT Stamping technology is widely applied in industrial production, sheet metal stamping is a kind of basic method of metal processing,it is used to produce all kinds of sheet metal parts, with high production efficiency, good dimensional accuracy and light weight, low cost and easy to realize mechanization and automation, etc.This article in view of the cylindrical parts blanking technology and deep drawing process, the design of deep drawing compound die for blanking.Its design notes including stamping manufacturability analysis, process scheme of layout design, drafting, drawing number, the rationality of the mould structure analysis, and the calculation of the die working size, the choice of stamping equipment.For blanking deep drawing die, the design of forming intensive also are quite important.To the standardization of design, as far as possible choose the standard parts, such as mold, mold base, pressing machine, etc. Non-standard parts structure design is given at the same time, with the corresponding part drawing, finally according to the requirement of the parts structure design and production of parts to generate the general assembly drawing. Key words: Composite molding; Blanking; Drawing; Assembly drawing 目 录TOC \o 1-3 \h \u HYPERLINK \l _Toc31926 前 言 PAGEREF _Toc31926 1 HYPERLINK \l _Toc31032 1. 工件分析 PAGEREF _Toc31032 2 HYPERLINK \l _Toc17668 1.1 分析工件冲压工艺性 PAGEREF _Toc17668 2 HYPERLINK \l _Toc18708 1.2 分析计算确定工艺方案 PAGEREF _Toc18708 3 HYPERLINK \l _Toc17466 1.2.1 确定工艺方案 PAGEREF _Toc17466 3 HYPERLINK \l _Toc17336 1.2.2 计算毛坯尺寸 PAGEREF _Toc17336 3 HYPERLINK \l _Toc7580 1.2.3 计算拉深次数 PAGEREF _Toc75