（毕业学术论文设计）-基于UG的自行车支架结构设计论文.docVIP

PAGE PAGE 1 摘 要 本篇毕业论文（设计）主要阐述了28寸自行车支架的设计过程，三维建模方法和关键零部件的强度校核，主要内容如下： 首先对28寸自行车的结构进行了分析，然后通过数据采集、实体测量等手段，完成整个自行车支架的设计。 最后采用UG4.2软件对自行车支架进行了三维建模. 关键次:自行车,支架,三维建模,UG软件 Abstract This thesis (design) on the main 28-inch bike stent design process, three-dimensional modelling and checking the strength of key parts and components, mainly as follows: First of all the 28-inch bike for the analysis of the structure, and then through data collection, measurement, and other entities means, to complete the bike stent design. Finally UG4.2 software used on a bike a three-dimensional modeling stent.