（毕业学术论文设计）-土木工程二级公路的设计.docVIP

文天学院2013届本科生毕业设计 摘 要 在本设计中，主要是进行二级公路的设计。主要设计部分为施工组织设计和工程估价设计部分的公路全长760m，设计车速60km/h，双向二车道，无中央分隔带。 对交通量进行了分析，查找相应技术规范，确定公路的等级以及设计需要的各种参数。在平面图中进行选线，然后又对道路路线进行了平面线形设计。在横断面的设计中，确定了横断面组成及各种要素后，绘制横断面图。路基设计的基本内容，就是确定路基边坡的形状和坡度。路面设计内容中包括路面类型与结构设计。最后的概算设计为计算机辅助计算，同时也给出了各部分内容相关的表格与图纸。 本次课程设计，我根据现场施工图纸和设计要求算出相应的工程量。然后编写施工组织设计，绘制施工平面图，施工横道图。根据工程量清单编写出工程量清单计价表，由工程量清单的相应措施费的费率得出本工程的措施费，然后再根据所得的措施费的结合相对应的税金、规费计算公式计算得到本工程的税金和规费。最后把表格和图整合到一起完成我的毕业设计。 关键词：二级公路；施工组织设计；工程估价；路面类型。 ABSTRACT In this design, is mainly designed for two grade highway. The main part of the design for construction organization design and value engineering design part of the highway length of 760m, the design speed of 60km\/h, two-way two lane, no central separate belt. For traffic flow was analyzed, find the corresponding technical specifications, highway to determine the levels of need and the design of the parameters. For the route selection in the horizontal plan, then to the road line for the plane alignment design. In the cross-sectional design, determines the cross-sectional composition and various elements, draws up the cross section chart. The basic contents of the roadbed design, is to determine the roadbed side slope form and slope. Pavement type and structure design of pavement design elements include. Design budget last for computer-aided calculation, but also gives the form and drawing the relevant part of the contents of the. The curriculum design, I according to the construction drawings and design requirements to calculate the corresponding quantity. Then write the construction organization design, drawing construction plan, Gantt chart. According to the engineering quantity list compiled by the engineering quantity list valuation table, the corresponding measures for engineering quantity list rate that the engineering measures fees, taxes, fees and then by combining the measures corresponding calculation formula to obtain the project taxes and fees. At the end of the