操作手册workbook-cern6.pdfVIP

Table of Contents 4.2.2 Physics Analysis Toolkit (PAT): Workflow1 Contents1 Introduction1 Pre-Creation3 Candidate Creation4 Candidate Selection4 Candidate Disambiguation5 PAT Trigger Event6 Review status7 i 4.2.2 Physics Analysis Toolkit (PAT): Workflow Detailed Review status Contents • Introduction • Pre-Creation • Candidate Creation • Candidate Selection • Candidate Disambiguation • PAT Trigger Event Introduction In this section you will find a description of the standard workflow of PAT. The creation of pat::Candidates starts from the AOD (or RECO) tier. The PAT Workflow (1) is organised in a main production sequence (called patDefaultSequence) and a parallel sequence for associating trigger information. An overview of the sequences is given in the figure below. The production of a standard pat::Tuple (1) consists of the following phases: • Pre-Creation: this phase includes steps, which can or have to be performed before the creation of pat::Candidates starts. • Candidate Creation: in this phase all extra information will be contracted into the pat::Candidates. • Candidate Selection: in this phase an extra selection step on the newly created pat::Candidate collections is supported. By default no selection is applied though. • Candidate Disambiguation: in this phase fully configurable extra information is added to support the disambiguation of reconstructed objects. • PAT Trigger Event: in this phase all trigger information available in the AOD (RECO) event co