拉伸与轧制预变形对2519A铝合金组织与力学-中国有色金属学报.PDF

20 6 2010 6 Vol.20 No.6 The Chinese Journal of Nonferrous Metals June 2010 1004-0609(2010)06-1088-07 2519A ( 410083) 2519A 165 θ′ θ′6%7% 472 MPa404 MPa15.6%472 MPa417 MPa9.4% θ′ 2519A TG146.21 A Effects of stretching and rolling pre-deformation on microstructures and mechanical properties of 2519A aluminum alloy ZHANG Xin-ming, LIU Ling, JIA Yu-zhen (School of Materials Science and Engineering, Central South University, Changsha 410083, China) Abstract: The effects of stretching and rolling pre-deformation on the microstructures and mechanical properties of 2519A alloy plate aged at 165 were investigated by hardness test, tensile test, transmission electron microscopy(TEM) and texture measurement. The results show that for both of the pre-deformation methods, proper pre-deformation leads to the quantity increasing and refinement of θ′ phase. But the inordinate deformation leads to an inhomogeneous distribution of θ′ phase, which decreases the elongation. For the 6% pre-stretching elongation and 7% pre-cold cooling deformation, the tensile strength, yield strength and elongation are 472 MPa, 404 MPa, 15.6% and 472 MPa, 417 MPa, 9.4%, respectively. Both of their tensile strengths are equivalent, but the yield strength of the pre-stretched alloy plate is lower, while the elongation is higher. The texture components and orientation density of the pre-stretched and pre-rolled alloy plates are almost the same, therefore, the yield strength of the alloy pla