木工施工的工艺及标准木工工程施工工艺流程木工材料的种类用途验收方法.docVIP

木工施工的工艺及标准.木工工程施工工艺流程木工材料的种类、用途、验收方法 Carpentry part depicts the houses five features, facial features if not correct, beautiful and not mentioned. For carpentry construction, you need to pay attention to the following points: 1. timber must be genuine, not shoddy, strictly according to the drawings, budget execution. 2. all new brick wall and bathroom wall made wooden decorations, such as wardrobe, modeling wall, must be in the brick wall and plywood surface brush 2 times after moistureproof paint, in order to carry out the next process. 3. of the original wall for the wood ornaments, such as door, window cover, foot line, must be affixed to a layer of waterproof paper. 4. solid lines and decorative panels in the same line of sight on the surface, the color texture must be tuned, relative. Port of 5. wood line, window cover, line line, line and proscenium closing panel must be tight, firm and smooth. 6. inside the furniture door, closet drawer wall, door mouth, obscure edges must be using wood flat wire (no inner panel except). 7. furniture, wooden door, foot line, ceiling, floor have strict operating standards. Furniture: use 18 mm wood board as furniture frame, 5 mm board as backboard, 12 mm wood board as drawer wall, 5 mm plate as drawer bottom board. Wooden door: use Chinese fir strip plus double 9 cm board and double face decoration panel for door. The thickness shall not be less than 4 cm. Foot line: use 15 mm wood board plus decorative panel plus solid wood line to do the foot line. Ceiling: gypsum board ceiling with wooden keel as a basis, and with the quality (GEM board) screws. Floor: floor must be rushed, the spacing for the middle of 24.4 cm (without plywood, except for the bottom), practical floor laying, and must be nailed to the floor with pine keel fixed. 8., kitchen, bathroom, aluminum gusset plate ceiling must use wooden frame as the base. 9. drawer rolling road not less than 3 screws, and other hinges, hinges and other hardware, a hole on a screw,