51单片机 R2R电阻网络 自制 DA AD 转换器 源代码及电路图.docxVIP

51单片机 R2R DA AD 转换器 数码管程序 #includeAT89x52.h #define uint unsigned int #define uchar unsigned char //DA输出引脚 #define DA_OUT P2 //比较器输入引脚 #define COMP_IN P1_3 //LED灯 #define LED_DA P1_1 #define LED_AD P1_2 //按键 #define BTN_1 P3_7 //个位+1 #define BTN_2 P3_6 //十分位+1 #define BTN_3 P3_5 //百分位+1 #define BTN_4 P3_4 //AD采样 //开关 #define SW_DA_AD P3_0 //0-DA 1-AD #define SW_DA_VALUE 0 #define SW_AD_VALUE 1 //AD转换定时器中断次数0~19 uchar T_AD_CONVERT_INT=0; //DA值 float DA_value_float=5.0; uchar DA_value_now=255; //单位为255分之1 //AD值 uchar AD_value_now=127; //数码管 uchar LEDS_TABLE[]={0x7e,0x30,0x6d,0x79,0x33,0x5b,0x5f,0x70,0x7f,0x7b,0x7e}; //common part #define HIGH 1 #define LOW 0 #define TRUE 1 #define FALSE 0 #define ZERO 0 #define MSB 0x80 #define LSB 0x01 //max7219 part #define DECODE_MODE 0x09 #define INTENSITY 0x0A #define SCAN_LIMIT 0x0B #define SHUT_DOWN 0x0C #define DISPLAY_TEST 0x0F //pin defined /***********************************************************************/ //change this part at different board sbit LOAD=P1^4; //MAX7219 Load-Data Input: rising edge pin 12 sbit DIN=P1^5; //MAX7219 Serial-Data Input: rising edge pin 1 sbit CLK=P1^6; //MAX7219 Serial-Clock Input: maximum 10MHz pin 13 //function define /***********************************************************************/ void Write_Max7219_byte(unsigned char temp);//write max7219 a byte void Write_Max7219(unsigned char address,unsigned char dat);//write max7219 command and data void Init_Max7219(void);//Initize max7219 //test program display from 1~8 /***********************************************************************/ /*void main(void) { unsigned char i; Init_Max7219(); while(TRUE) { for(i=1;i9;i++) { Write_Max7219(i,i); } } } */ /***********************************************************************/ void Write_Max7219_byte(unsigned char temp) { unsig