《某型矿用负压力传感器硬件设计论文》-毕业论文.docVIP

l 本科毕业设计(论文) 题目：某型矿用负压力传感器硬件设计 院 （系）： 电子信息工程学院 专 业： 自 动 化 班 级： 学 生： 学 号： 指导教师： 年 06月10日 某型矿用负压力传感器硬件设计 摘 要 本课题所涉及的压力传感器可以满足井下压力测试的基本要求，采用红外线遥控调校，密封性能良好，仪器具有多种信号输出制式，通过四位LED显示输出结果，可与国内各种监测系统配套使用。 本文主要阐述了基于89C52单片机的某型矿用负压力传感器的硬件电路设计。该型传感器是采用半导体差压探头制成的固定式智能负压测量仪表。压力测量是采用半导体压力敏感电桥，工作时电桥由恒压源供电。电桥输出与正负测量压力差成正比的电压信号。仪器由电源电路、测量电桥电路、放大电路、A/D转换电路、信号调理电路、显示电路、信号输出电路等构成。 关键词：. 测量电桥电路；压力传感器；红外线遥控；89C52型单片机。 A certain type of pressure sensor used in the mine hardware designs Abstract The issues involved in the pressure sensor can meet the basic requirements for testing.It is used of infra-red remote to control the pressure sensor,good sealing performance.Instrument has a wide range of standard signal output, through the four LED display output results, with the use of various monitoring systems. This text mainly elaborated to design with the hardware electric circuit that the negative pressure spreads a feeling machine according to a certain mineral of 89 C52s single slice of machine.That type of spread a feeling machine is to adopt semi-conductor bad press to stretch forward to make into of fixed type intelligence negative press diagraph appearance.The pressure diagraph adopts the semi-conductor pressure sensitive electricity bridge and work give or get an electric shock bridge from constant pressure source power supply.Give or get an electric shock bridge exportation and plus or minus diagraph pressure bad become the electric voltage signal of direct proportion.Instrument from the power electric circuit, measure an electricity bridge electric circuit, enlarge electric circuit and A/D conversion the electric circuit, signal adjust reason elect