A Noniterative Optimized Algorithm for Shunt英文版本.pdf

5376 IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, VOL. 60, NO. 12, DECEMBER 2013 A Noniterative Optimized Algorithm for Shunt Active Power Filter Under Distorted and Unbalanced Supply Voltages Parag Kanjiya, Vinod Khadkikar, Member, IEEE , and Hatem H. Zeineldin, Member, IEEE Abstract—In this paper, a single-step noniterative optimized Active power filters (APFs) are widely used to overcome algorithm for a three-phase four-wire shunt active power filter such power quality problems [2]–[5]. There are two main under distorted and unbalanced supply conditions is proposed. APF control strategies for load compensation when the supply The main objective of the proposed algorithm is to optimally determine the conductance factors to maximize the supply-side voltages are unbalanced and distorted [6]–[13]: 1) harmonic- power factor subject to predefined source current total harmonic free (HF) source currents and 2) unity-power-factor (UPF) distortion (THD) limits and average power balance constraint. source currents. The HF strategy results in sinusoidal source Unlike previous methods, the proposed algorithm is simple and currents [6], while the UPF strategy can achieve minimum root- fast as it does not incorporate complex iterative optimization mean-square (rms) source current magnitudes. Additionally, techniques (such as Newton–Raphson and sequential quadratic programming), hence making it more effective under dynamic the UPF strategy can provide effective damping to avoid any load conditions. Moreover, separate limits on odd and even THDs resonance [7], [8]. Both HF and UPF control strategies