双电机异步驱动的三端口级联多电平变换器及再生能量分配系统.PDF

第 38 卷 第 6 期 中 国 电 机 工 程 学 报 Vol.38 No.6 Mar. 20, 2018 2018 年 3 月 20 日 Proceedings of the CSEE ©2018 Chin.Soc.for Elec.Eng. 1799 DOI ：10.13334/j.0258-8013.pcsee.162641 文章编号：0258-8013 (2018) 06-1799-11 中图分类号：TM 46 双电机异步驱动的三端口级联多电平变换器及 再生能量分配系统 王盼，刘飞，查晓明，宫金武，冯锟，熊晓琪 (武汉大学电气工程学院，湖北省 武汉市 430072) Tri-port Cascaded Multilevel Converter System for Two-motor Asynchronous Drive and Its Regenerative Energy Distribution WANG Pan, LIU Fei, ZHA Xiaoming, GONG Jinwu, FENG Kun, XIONG Xiaoqi (School of Electrical Engineering, Wuhan University, Wuhan 430072, Hubei Province, China) ABSTRACT: In order to drive multi-motor in industrial field 边形变换器拓扑结合构成一个三端口 AC/AC/AC 结构。其 and recycle their regenerative energy, a tri-port cascaded 中，H 桥级联变换器每单元前端通过移相变压器接入电网， multilevel converter for two-motor asynchronous drive was 作为输入端口；六边形拓扑相邻顶点则构成两交流输出端 proposed. The H-bridge cascade multilevel converter and the 口。采用恒压频比控制，结合功率分配分析，分别给定两输 hexagonal topology were combined to form a tri-port 出端口控制信号，驱动双电机异步运行。六桥臂可等效为两 AC/AC/AC system, in which the front end in each cell of 组耦合三相对称电源，将一台电机再生能量转移供给另一台 H-bridge converter was connected to the main grid by a phase 电机的电动运行，以此提出新的能量流动路径，降低单元直 shifting transformer as the in-port, and the two out-port were 流侧电容电压泵升。以 12 单元 6 桥臂的三端口级联多电平 connected to the endpoints of the hexagonal converter. 变换器为例，通过 Matlab 仿真及实验结果验证了该拓扑及 Considering the analysis of power distribution, two different 控制策略的可行性和有效性。 control instructions based on V/f control were sent to drive two 关键词：三端口级联多电平；六边形；双电机异步运行；功 asynchronous-operation motors. The six branches of converter 率分配；再生能量利用 equ