《四路土壤湿度测量显示系统》-毕业论文设计.docVIP

四路土壤湿度测量显示系统 PAGE 27 摘要 【内容与技术参数】1、用数码管显示 2、四路循环显示 3、精度达到1% 【要求及摘要】本设计的要求： 1、画出完整的电路原理图 2、写出完整的程序 3、毕业设计说明书不少于8000字 本设计概要：本设计是关于四路土壤湿度测量与显示的设计与制作。该设计的工作原理是由单片机STC89C51和模数转换器ADC0809共同完成功能，首先湿度传感器将采集到的数据传送到ADC0809的IN端作为输入端的模拟信号，ADC0809根据送来的地址信号选通IN3通道，然后对输入的模拟信号进行模数转换，转换结束时，EOC输出高电平，通知单片机可以读取转换结果，单片机通过调用中断程序，读取转换后的数据。最后，单片机把采集到的湿度数据经过软件程序处理后送到LED数码管进行显示。而且这个设计我只用一个湿度传感器，它包括模数转换，可直接接单片机输出数据。另外三路准备用可调电阻进行模拟，调节电阻阻值，改变输入电压，相当于改变土壤湿度，再传到模数转换器进行转换再输入单片机进行输出。 【关键词】LED液晶；湿度传感器；AD转换器芯片；单片机STC89C52 Abstract 【The content and the technical parameters 】 1, with LED display 2, four ways of cyclic display 3, 1% accuracy 【 requirements and the 】 this design requirements: 1, draw the complete circuit principle diagram 2, write a complete program 3, graduation design specifications of not less than 8000 words This design summary: this design is about four ways of soil humidity measurement and display design and production. The design principle of work is STC89C51 by single-chip microcomputer and adc ADC0809 together complete function, first humidity sensors will the collected data transfer to the ADC0809 IN end as input terminal of the analog signals, ADC0809 according to the address of the signal sent choose IN3 channel, and then the input analog signal conversion module, at the end of the conversion, EOC output high level, notice the microcontroller can read the transformation results, SCM by calling the interruption program, read after converting data. Finally, the acquisition of the single chip microcomputer to humidity data after software program after processing LED digital display to pipe. And the design I only use a humidi