《某型搅拌器选型与设计》-毕业论文（设计）.doc

精品 毕业设计（论文） 某型搅拌器选型与设计 摘 要 本文主要介绍了气相、液相、固相不同物质混合搅拌的方式、流型、搅拌器的选型及应用。 气液接触过程的主要有有以下几种：气相和液相需要的停留时间分布、允许压力降、相对质量流率、是否逆流接触、局部混合能力、是否需要补充或移出热量、腐蚀条件、泡沫行为与相分离、反应时需要的流型、反应与传质的关系、层流和过渡区的流变行为等。这些因素又大都与搅拌器关系密切。 搅拌槽内的气体分散大致有以下几个状态：气泛状态（大部分气体未分散，气泡沿搅拌轴直接上升到液面），载气状态（气体基本得到分散，分布器以下分布不良），完全分散状态。气液分散搅拌器主要有三种：通气式、自吸式和表面更新式。 关键词：气液搅拌;液固搅拌;液液搅拌 Abstract This article mainly introduced the gas phase, liquid and solid phase different material mixture stirring way, flow pattern, blender the selection and application. The process of gas and liquid contact are mainly have the following kinds：Gas and liquid needs retention time distribution, allow for pressure drop, relative mass flow rate, and whether counter-current contact, local mixed ability, whether to need to supplement or remove heat, corrosion condition, foam behavior and phase separation, reaction when flow type and the reaction to the relationship, given and laminar and rheological behavior transition region. These factors and mostly close relations with the blender. Mixing the groove gas roughly the following several state scattered：Gas pan state (most of the gas bubble without stirring shaft of scattered along, rose to liquid surface) direct carrier gas state (gas, has been basically dispersed, distribution device, the following distribution bad), completely decentralized state. Gas-liquid scattered blender basically has 3 kinds: ventilation type, of self-suction and surface more modern. Keywords: gas-liquid mixing; the liquid-solid stirring; Liquid-liquid mixing 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc291683171 第一章 气相与液相的混合搅拌 PAGEREF _Toc291683171 \h 1 1. HYPERLINK \l _Toc291683172 1.简介 PAGEREF _Toc291683172 \h 1 1. HYPERLINK \l _Toc291683173 2.气液搅拌设备的结构类型 PAGEREF _Toc291683173 \h 1 1. HYPERLINK \l _Toc291683174 2.1 通气式 PAGEREF _Toc291683174 \h 1 1. HYPERLINK \l _Toc291683175 2.2 自吸式 PAGEREF _Toc291683175 \h 1 1. HYPERLINK \l _Toc291683176 2.3 表面更新式 PAGEREF _Toc291683176 \h 2 1. HYPERLINK \l _Toc291683177 3.流型