单相液晶双向电能表的设计论文-毕业(学术)论文设计.docVIP

摘 要 该系统主要由显示模块、键盘模块、时钟模块、存储模块、通讯模块、CPU模块、CS5460A电能表芯片模块和前端电路调理模块部分组成。前端电路调理模块采用220V/5V的电压互感器和50A/25mA电流互感器和精密电阻实现对市电的转换，并采用RC滤波网络滤波,然后采用由美国CRYSTAL 公司的新型电能计量芯片CS5460芯片实现对电流、电压和电能的测量与转换；时钟模块采用DS1302时钟芯片为系统提供时钟基准，存储模块采用AT24C02，为系统提供数据存储；显示模块用LCD12864液晶，指示模块使用LED发光二极管，指示正向电能和负向电能，通信模块采用Max485芯片，并利用MSP430组成的CPU模块控制所有芯片的工作、测量、计算电能，送往显示模块和存储模块进行实时显示和存储。 关键字：CS5460A；MSP430；485通讯；LCD12864；DS1302 江苏科技大学本科毕业设计（论文） II Abstract This system is mainly revealed the module, keyboard module, clock module, store module, communicate module, CPU module, CS5460A electric energy meter chip module and front circuit look after the part of the module to make up. The front circuit recuperates the module and adopts electric current mutual inductor and 220V/5V electric current mutual inductor and accurate resistance of 50A/25mA to realize the conversion of the city electricity, and adopt RC to strain the wave network and strain the wave, then adopt measure chip, CS5460 of chip, realize to electric current, voltage, measurement and conversion of electric energy by new electric energy of Company, CRYSTAL of U.S.A.; The clock module adopts DS1302 clock chip to offer the clock basis for system, stores the module and adopts AT24C02, offer the data for system to store; Reveal the module uses LCD12864 liquid crystal, Instruction module USES LED light emitting diode, instructions, positive electricity and negative electricity ,the communication module adopts Max485 chip, and utilize CPU module that MSP430 makes up to control the work of all chips; Measure, calculate electric energy, send to is shown the module and stores the module and pays revealing and storing in real time. Keywords: CS5460A; MSP430; 485communication;LCD12864;DS1302 IV III 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295356364 第一章 绪论 PAGEREF _Toc295356364 \h 1 HYPERLINK \l _Toc295356365 1.1 选题的目的和意义 PAGEREF _Toc295356365 \h 1 HYPERLINK \l _Toc295356366 1.2 电能表的发展概况 PAGEREF _Toc295356366 \h 1 HYPERLINK \l _Toc295356367 1