温拌再生沥青混合料水稳定性评价论文-毕业(学术)论文设计.docVIP

李俊：温拌再生沥青混合料水稳定性评价 2012届材料科学与工程专业毕业论文 PAGE 24 PAGE 1 摘 要 本文采用冻融劈裂试验，对掺有40%RAP旧料的温拌再生沥青混合料的水稳定性进行了评价。具体分为对RAP回收沥青路面材料过2.36mm筛与未过2.36mm筛所构成的温拌再生沥青混合料的水稳定性进行评价，并探究了分别掺入分散剂与SBR胶乳后对温再生沥青混合料水稳定性的影响。 首先，对原材料进行性能指标评价，得到RAP旧料的级配与油石比，然后设计温拌再生沥青混合料的配合比，确定温再生的最佳成型温度。最后再通过冻融劈裂试验，对再生料进行水稳定性评价。 试验结果表明，通过对RAP旧料做过筛处理，可提高温拌再生沥青混合料的水稳定性。加入分散剂后，分散剂掺量较低时可以改善再生料的水稳定性，但掺量较高时反而会降低其水稳定性。加入适量SBR胶乳后，同样能改善再生料的水稳定性，但掺量较高时，效果并不明显。 关键词：温拌沥青混合料，水稳定性，分散剂，SBR胶乳 ABSTRACT In this paper, freeze-thaw splitting test has been used to evaluate the moisture susceptibility of warm mix asphalt with 40% RAP. Including the evaluation of moisture susceptibility of WMA made of RAP (passed and not passed 2.36mm screen), and the influence of WMA with RAP mixed of Dispersant and SBR. At first, acquire the gradation and bitumen-aggregate ratio from the evaluation of the RAP. Then design the asphalt mix proportion of WMA with RAP, and determine the best molding temperature of WMA. At last, evaluate the moisture susceptibility of wma with RAP by freeze-thaw splitting test. Simulation results show that: (1)the moisture susceptibility of WMA with RAP can be improved from screening the RAP.(2)the moisture susceptibility can also be improved when mixed with optimal Dispersant or SBR, but once the dispersant and SBR content is increased, the effect is not that obvious. KEY WORDS: WMA with RAP, Moisture Susceptibility, Dispersant, SBR 目录 TOC \o 1-3 \f \h \z HYPERLINK \l _Toc327008285 第一章 绪 论 PAGEREF _Toc327008285 \h 1 HYPERLINK \l _Toc327008286 1.1 研究背景与意义 PAGEREF _Toc327008286 \h 1 HYPERLINK \l _Toc327008287 1.2 国内外的研究状况 PAGEREF _Toc327008287 \h 2 HYPERLINK \l _Toc327008288 1.2.1 温拌再生沥青混合料简介 PAGEREF _Toc327008288 \h 2 HYPERLINK \l _Toc327008289 1.2.2 温拌再生沥青混合料水稳定性研究 PAGEREF _Toc327008289 \h 3 HYPERLINK \l _Toc327008290 1.3 研究内容及技术路线 PAGEREF _Toc327008290 \h 3 HYPERLINK \l _Toc327008291 1.3.1 主要研究内容 PAGEREF _Toc327008291 \h 3 HYPERLINK \l _Toc327008292 1.3.2 试验技术路线流程图 PAGEREF _Toc327008292 \h 5 HYPE