《ControlLogix培训7》-公开·课件设计.pptVIP

ControlLogix Redundancy Main Redundancy Features Optimized for availability of control. Absolutely no user programming required to implement. Bumpless switchover guaranteed for any outputs controlled by logic in the highest priority task. Switchover within approximately 100 msec. Works with standard Logix5555 controllers and ControlNet Bridges (Series D or higher). Switchovers are transparent to any devices networked to the redundant controller chassis. Transparent cross-load of programs from primary to secondary controllers. On-line workstation configuration/commands/edits to primary are automatically forwarded to secondary. User can choose to cancel or resume ‘test edits’ at switchover. Building a Typical Redundant System Other Redundant Architecture Considerations Only Logix5555’s, ControlNet Bridges, and a single System Redundancy Module can be placed in a redundant controller chassis. All I/O must be remote from the redundant controller chassis. To connect to other networks, bridge through another ControlLogix chassis. Logix5555 Controller New CPU ASIC Provides alternative memory parity encoding method so that higher density commercial memory may be used. New memory change detection algorithms for Redundancy. New circuitry to support new 1.5, 3.5, and 7.5 Mbyte memory cards. Increased Performance Faster Flash-Memory to increase operating system performance. Movement of Floating Point library to RAM for higher performance (30% faster than L1). Hardware changes to support ControlLogix redundancy. New Real Time Clock (RTC) chip with increased accuracy. In redundancy, data is buffered in the secondary controller, so twice as much data memory space is required. ControlNet allows transparent switchovers The 1756-CNB Series D has added the necessary hardware and firmware changes to support ControlLogix redundancy. You set the same ControlNet address on the rotary switches of the primary and secondary CNB’s. The primary CNB will use that address, and the secondary CN