钢铜塑三层复合材料端面摩擦条件下的温度场研究-机械设计及理论专业论文.docxVIP

Research Research on Temperature Field of Layered Composites of Steel-Copper-Plastics under End-face Frictional Conditions Abstract The steel-copper-plastic material with layered structure．composed of low carbon steel，copper powder and polyoxymethylene(POM)or modified POM，is one虹nd ofoil- less self-lubrication composites．It has high loading capacity besides its self-lubrication． The steel provides the composite high strength and loading capacity,the middle-layer of copper powder supplies the effects of rapid heat transfer ability and holding the polymeric surface layer which acts as solid lubrication．This kind of composites conquers the low strength of pure plastics，and has some typical performances，for example， excellent heat exchange．small linear expansion coeffident and high anti．abrasion．It 8till retalas the self-lubrieation ofplasties．Therefore．it has been used widely to produce serf-lubrication bearings． In this the出．the丘iction and wear behaviors of the composite with the surface layer of pure POM or POM filled bY llano-MoS2 particles were firstly investigated via the elld-face tribometer．It was found that the wear resistance and friction reduction of POM丑Ued with nano-MoS2 particles were higher those of pure POM．Secondly, a three-dimensional transient．state mathematical model described the heat transfer behavior which was resulted from the friction on the rubbing surface of the composites was established based on the heat transfer theory,tribological principle and finite element method．At last，it was studied that the finite element model of the composites by means of ANSYS software and the temperature fields on the robbing surface under end-face conditions．The temperature distribution8 on the surface layer were studied in case of different polymer composites．and the simulation results were compared with the experimental results as well．The results showed the heat conducti诎y of POM mled by nano-MoS2 particles wma higher that that of POM．In the end，it was obta