基于PROFIBUS-DP主站和从站通信.PDFVIP

第40 卷第1期 武 汉 工 程 大 学 学 报 Vol.40 No. 1 第1期 2018 年2 月 Journal of Wuhan Institute of Technology Feb. 2018 文章编号：1674 - 2869 （2018 ）01 - 0083 - 04 基于PROFIBUS-DP 主站与从站的通信 聂 辉，秦实宏* 武汉工程大学电气信息学院，湖北 武汉 430205 摘 要：在工业控制现场，针对上位机离输入/输出（I/O ）设备远，对I/O 设备的控制实时性较差，设计一个 基于过程现场总线分散式通信（profibns field bus- dencentralized periphery ，PROFIBUS- DP ）的主从站通信系 统。该系统使用西门子工业控制软件STEP7 为平台，采用可编程逻辑控制器（programmable logic controller ， PLC ）S7-300 为主站控制器，分布式I/O 设备ET 200M 为从站控制器。首先建立PLC 和ET 200M 进行硬件组 态，将其作为软件设计的基础。然后完成系统的网络组态设计及资源分配，最后仿真验证了上位机对远程 I/O 设备控制的可行性。该设计满足工业精准控制远程设备的要求，降低了电缆布线的成本，同时提高系 统的可扩充性。 关键词：PROFIBUS-DP ；主从通信；PLC 中图分类号：TN914 文献标识码：A doi ：10. 3969/j. issn. 1674⁃2869. 2018. 01. 015 Master-slave Communication System Based on PROFIBUS-DP NIE Hui ，QIN Shihong* School of Electrical and Information Engineering ，Wuhan Institute of Technology ，Wuhan 430205 ，China Abstract ：In the scenario of industrial control ，the long distance between the host computer and its Input/ Output （I/O ）devices leads to poor performance of real-time controlling. To solve this issue ，we designed a master-slave communication system based on PROFIBUS-DP. This system adopted the SIEMENS industrial control software STEP7 as its platform ，in which programmable logic controller （PLC ）S7-300 was used as a master controller ，and the distributed I/O device ET200M was used as a slave controller. Firstly ，the configurations of PLC and ET 200M were established as a basis for the software design. Next ，the communication network was designed and its resource was distributed. Finally ，the simulation was conducted to prove the feasibility for the host computer control