龙门式数控火焰切割机结构设计(毕业设计目论文).docVIP

图书分类号： 密 级：  毕业设计(论文) 龙门式火焰切割机传动及控制设计 THE DESIGN OF TYANSMISSION AND CONTYOL in the gANTRY FLAME CUTTING MACHINE 学生姓名 学院名称 专业名称 指导教师 20**年 5月 27日 徐州工程学院毕业设计(论文) PAGE I 摘要 本课题针对龙门式火焰切割机的横梁及火焰切割头的控制进行了设计。横梁的机构设计主要对其结构的确定，之后对传动装置进行了选择及计算检验，最后对主要传动的零部件进行选择校核。其中主要对滑动丝杠和滚动丝杠的强度及传动效率等进行了计算校核。并对横梁设计中存在的结构部件的联接问题进行了改进。火焰切割头是在传动装置的基础上运用丝杠的转速控制运动，用单片机控制电机的转速来达到效果。对控制电路设计也做了系统的详解，主要对所涉及的键盘、显示器、主要芯片做了选取应用。 关键词 火焰切割机；电气控制；横梁设计；单片机 Abstract This essay analyzes that the design of the beam and the control of flame cutting head of the gantry flame cutting machine.The design of the beam of mechanism main determining its structure of the transmission device, then the selection and operation of the main transmission inspection, finally the choose of the parts inspection. The major of sliding screw and rolling ball screws strength and transmission efficiency is calculated respectively.And problems existing in the connect of parts, in the design of structure of the beam ,are also improved. Flame cutting in the head is based on transmission device using screw speed control movement, with single-chip microcomputer control motor speed to achieve results. I also make a system explanation of the control of circuit design, involved mainly to make the selection and applications of the keyboard, display, main chip. Keywords flame cutting machine electrical control the design of the beam microcontroller 徐州工程学院毕业设计(论文) PAGE I 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295681964 摘要 PAGEREF _Toc295681964 \h I HYPERLINK \l _Toc295681965 Abstract PAGEREF _Toc295681965 \h II HYPERLINK \l _Toc295681966 1 绪论 PAGEREF _Toc295681966 \h 1 HYPERLINK \l _Toc295681967 1.1 课题的意义、目的、研究范围及要达到的技术要求 PAGEREF _Toc295681967 \h 1 HYPERLINK \l _Toc295681968 1.1.1 课题的意义和目的 PAGEREF _Toc295681968 \h 1 HYPERLINK \l _Toc295681969 1.1.2 研究范围和技术要求 PAGEREF _Toc295681969 \h 1 HYPERLINK \l _Toc295681970 1.2 龙门式火焰切割机的简介和特点 PAGEREF _Toc295681970 \h 1 HYPERLINK \l _Toc295681971 1.2.1 简介 PAGEREF _