KXKT型空间方管桁架相贯节点承载力分析及实用计算公式.docx

西安建筑科技大学硕士论文Bearing 西安建筑科技大学硕士论文 Bearing Capacity Analysis of Multiplanar KX一，KT-joints Made of Square Hollow Sections and Practical Design Formula Speciality：S缸ucture Engineering Name： Yangjunfen Instructor：Guqiang Professor Abstract As structural component，square hollow steel sections have favorable properties for resisting compression．bending and torsion．The structures made of square hollow steel sections by using the directly welded joints are fabricated easily and economically, which Call be found in many applications all over the world．But刀oH(the research on the multiplanar KX·，KT-joints that have been used in many projects is little，which brings some inconvenience to the extension and application for this type ofjoints． The key problem in the designing of this sfructure is the ultimate bearing capacity of the directly welded joints(also called simple joints)．Because the stress distribution around the rjoint is complicated，it is restricted using analytical method to calculate its bearing capacity,and the commonly research approaches to this joint are experimental investigation and finite element modeling．In this paper,the finite element modeling method is used to do some plasto elasticity lager defection analysis for the multiplanar KX一，KT-joints．First，the bearing capacity ofuniplanar K-，T-，and x-joints is analyzed． And then the multiplanar KX一，KT-joints is analyzed，the analysis results of which is contrasted with the former,SO as to consider the effect on bearing capacity owing to the mutual effect of web member and branch member．At last，the suggested design formula ofthe bearing capacivy for these two types ofjoint is presented． Key words：Tubular structure，Simplejoint，Ultimate bearing capacity，FEM Research type：Applied research Il 声 声 明 本人郑重声明我所呈交的论文是我个人在导师指导下进行的研究工 作及取得的研究成果。尽我所知，除了文中特别加以标注和致谢的地方外， 论文中不包含其他人已经发表或撰写过的研究成果，也不包含本人或其他 人在其它单位已申请学位或为其它用途使用过的成果。与我一同工作的同 志对本研究所做的所有贡献均已在论文中作了明确的说明并表示了致谢。 申请学位论文与资料若有不实之处∥本人承担一切相关责任。 论文作者签名：扬俭务 日期：∽二，孑、如 关于论文使用授