尚观CCNA最新题库(2012年12月之前有效)537道全V108.8.pdfVIP

1.Refer to the exhibit. What could be possible causes for the Serial0/0 is down interface status? (Choose two.) A. A Layer 1 problem exists. B. The bandwidth is set too low. C. A protocol mismatch exists. D. An incorrect cable is being used. E. There is an incorrect IP address on the Serial 0/0 interface. Answer: AD 2. Before installing a new, upgraded version of the IOS, what should be checked on the router, and which command should be used to gather this information? (Choose two.) A. the amount of available ROM B. the amount of available flash and RAM memory C. the version of the bootstrap software present on the router D. show version E. show processes F. show running-config Answer: BD 3.Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is shown in the exhibit? (Choose two.) 尚观知识库 A. Host E and host F use the same IP gateway address. B.Router1 and Switch2 should be connected via a crossover cable. C.Router1 will not play a role in communications between host A and host D. D.The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces. E.Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit. F.The FastEthernet 0/0 interface on Router1 and Switch2 trunk ports must be configured using the same encapsulation type. Answer: DF 4. Refer to the exhibit. Which two statements are true about the loopback address that is configured on RouterB? (Choose two.) 尚观知识库 A. It ensures that data will be forwarded by RouterB. B. It provides stability for the OSPF process on RouterB. C. It specifies that the router ID for RouterB should be . D. It decreases the metric for routes that are advertised from RouterB. E. It indicates that RouterB should be elected the DR for the LAN. Answer: BC 5. A network administr