型腔类零件自动编程.docVIP

摘 要 PAGE 2 编号 08 淮安信息职业技术学院 毕业论文 题 目 型腔零件数控自动编程设计 学生姓名 孔军军 学 号院 系 机电工程系 专 业 数控技术 班 级 230112 指导教师 喻步贤 副教授 顾问教师 二〇一四年六月 摘 要 PAGE I 摘 要 本次毕业论文设计的目的主要是运用UG软件对某型腔类零件的自动编程过程进行介绍，并针对型腔零件的数控铣削加工设计。本毕业设计在本零件的设计过程中以日常生产中的工艺设定方法为主，参考专业资料为辅，运用UG软件根据图纸的尺寸要求制出零件的实体三维造型，并对零件进行图形分析及工艺分析，确定加工方法及所需的加工刀具等，确定好工序，然后运用UG软件对零件进行编程处理，并模拟出刀轨，进行对比发现需要改进的地方，并及时优化。最后通过后处理生成零件的加工程序，并在机床上进行实际加工。 关键词：加工工艺 自动编程 后处理 Abstract Abstract Abstract Abstract The graduation thesis is mainly based software UG Parts of a cavity automatic programming process introduced, and mold parts for CNC milling parts design. The graduation project in this part of the design process to the process set daily production methods, and consult professional information, supplemented by the use of software UG size requirements based on drawings made out of solid three-dimensional modeling of parts, and the parts for graphical analysis and process analysis to determine the processing methods and the required processing tools, etc., to determine a good step, and then use the parts UG software programming process and simulate the tool path for comparison found areas for improvement, and timely optimization. Finally, post-processing is to generate the machining program, and the actual processing on the machine. Results By the actual machining operation on the machine shows that the processing of the drawing fully meet the requirements of parts and facilitate the actual production. Keywords: UG automatic programming tool path Trajectory simulation After-treatment 目 录 目 录 PAGE III 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc370764126 摘 要 PAGEREF _Toc370764126 \h I HYPERLINK \l _Toc370764127 Abstract PAGEREF _Toc370764127 \h II HYPERLINK \l _Toc370764128 第一章 绪论 PAGEREF _Toc370764128 \h 1 HYPERLINK \l _Toc370764129 1.1 UG简介 PAGEREF _Toc370764129 \h 1 HYPERLINK \l _Toc370764130 1.2 UG软件应用 PAGEREF _Toc370764130 \h 1 HYPERLINK \l _Toc37076