模拟信号数字无跟线传输系统的设计.docVIP

目 录 摘 要1 关键词1 Abstract 1 Key words 2 1 前言2 1.1 选题的目的与意义 2 1.2 简述模拟信号与数字信号 2 2 设计任务与要求 2 2.1 设计任务 2 2.2 基本要求 3 3 总体方案设计与方案论证 3 3.1总体方案设计 3 3.2 方案论证与选择 4 3.2.1 无线传输方式的选择 4 3.2.2 模数转换 4 4 硬件电路与软件设计的实现 8 4.1 硬件电路的实现 8 4.1.1 控制处理器外围电路 10 4.1.2 红外发射电路的实现 10 4.1.3 模数转换电路的实现 10 4.2 软件设计 11 4.2.1 发射机软件设计 11 5 系统调试与调试中的问题 12 5.1 模数转换的调试 12 5.2 红外发射接收的调试 12 参考文献 13 附 录 13 附录1 发射机程序 13 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 2 模拟信号数字无线传输系统的设计 摘 要 通信系统分为模拟通信系统和数字通信系统，如果我们在发送端的信息源中包括一个模/数转换装臵，在接收端包括一个数/模转换装臵，在发送端与接收端之间通过红外作为载波进行通信，则可以实现模拟信号数字无线传输。本文主要从三个方面进行设计与实现：（1）AT89S51单片机对A/D转换器的控制，从而对模拟信号进行抽样、量化、编码后转换为数字信号；（2）单片机对数字信号进行编码与38Khz红外载波调制通过红外线发射；（3）接收机接收到的调制信号经红外接收头进行解调还原数字信号，再经单片机的处理，通过D/A，以及信号的放大，最后再经过低通滤波器还原成模拟信号，从而实现模拟信号数字无线传输演示的全过程。 关键词:模拟信号数字传输；无线传输；红外通信；模数转换 Analog Digital Wireless Transmission Communication System Abstract Communication system is divided into analog communication systems and digital communication systems, if we send the clients information sources include a A / D converter, the receiver includes a D / A converter, in between the transmitter and the receiver as by infrared carrier to communicate, you can transmit analog signal digital infrared communications. This article mainly focuses on three aspects: (1) AT89S51 microcontroller on the A / D chip to control the analog signal sampling, quantization, encoded into digital signals; (2) single chip digital signal processing and modulation 38KHZ IR through infrared emission; (3) base station receives the first modulated signal by the infrared receiver to demodulate digital signal reduction by the microcontroller processing, through the D / A, and signal amplification and finally through the reduction of low-pass filter into an analog signal, in order to achieve different place communication. Key words: Analog signal digital transmission ；wireless transmission ；infrared communication ；analog _digital conversion 1 前言