弯曲刚度模型的构建-华南农业大学学报.PDF

第29 卷第3 期 华南农业大学学报 Vol. 29 , No.3 2008 年7 月 Journal of South China Agricultural University JuL 2∞8 尾巨按单板/金属网复合层积材 弯曲刚度模型的构建 李 鹏，胡传双，李凯夫，邓燕平 (华南农业大学林学院，广东广州 51凶42) 摘要:根据复合材料力学中的经典层积材理论构建了尾巨按单板/金属网复合层积材弯曲刚度的预测模型-经对 由 20 、40 和 60 目不锈钢金属同所组成的尾巨按单板/金属网层积材进行模型验证，当不锈钢金属网为 20 和 40 目 时，模型预测值与实测值具有很好的吻合度，相对误差分别为 7.75 %与1. 38 %，但日数为 60 日时，相对误差却达 到了 84.59%. 结果表明，构建的模型能够准确预测尾巨按单板/金属网层积材的弯曲刚度. 关键词:层积材;弯曲刚度;不锈钢金属网;模型 中图分类号:TB330.1 文献标识码:A 文章编号: 1001-411X(2008)03-∞96-05 Modeling the Bending Stiffness of the Laminated Eucalyptus Veneer/Steel Mesh Lumber LI Peng , HU Chllan-shllang , LI Kai -fll , DENG Yan-ping (College of Forestry , South China Agricultural University , Guangzhou 510642 , China) Abstract: The bending stiffness of the laminated ellcalyptlls veneerlsteel mesh lllmber was modeled ac- cording to 出e theory of the classical laminated composites wi出 the llltimate pllrpose of predicting the de- sign strength vallle and optimizing its engineering applications. The lllmbers llsing Eucalyptus urophylla s. T. Blake x E. grandis W. Hill ex Maiden veneer and three different types of steel meshes were laminat- ed to verify the proposed mode l. The reslllts showed that the bending elasticity calclllated by the proposed model had a good agreement with the bending elasticity measured by the three point bending test when the mesh grits llsed were 20# and 40# , and the relative error were 7. 75% and 1. 389毛， and 出is implied 出at the proposed model was reliable in predicting the bending elasticity