驾驶舱门锁故障处置.pptVIP

驾驶舱门锁故障分析 车间:波音车间 作者:李 寅  索 引 一 故障描述 二 排故过程 三 故障分析 四 总结 故障描述 航后机组告知飞机出现LOCK FAIL故障 注：FLIGHT DECK ACCESS SYSTEM电门在闭合位置（NORM） 排故过程 1.将FLIGHT DECK ACCESS SYSTEM电门放在闭合位置（NORM） 2.再将P8-47面板上的S2旋钮放在AUTO位置 3.重置电气面板DOOR LOCK（E-1）跳开关 4.LOCK FAIL灯灭，故障排除 故障分析 根据FIM手册52-50-00-810-809 可能引起LOCK FAIL灯亮判断有四种原因 如下 1.Electric Strike, M2538 2.Control Panel Switch/Light Module P8-47 3.Door Access Controller/Chime Module 4.Wiring 位置图如下     根据FIM手册排故初始步骤 1.Open the flight compartment door. 2.Put the power switch on the chime module, M2537 to the NORM position. 3.Make sure that the flight compartment door lock switch, S2 is in the AUTO position. 4.Make sure that the LOCK FAIL light on the P8-47 panel is on. 5.If the LOCK FAIL light is on, then do the Fault Isolation Procedure below. 6.If the LOCK FAIL light is not on, then there was an intermittent fault.  进行第六步的时候，故障排除，说明故障为一间歇性故障 如果到此故障没有排除，则进行第五步的 Fault Isolation Procedure 步骤如下  1.Make sure that the flight compartment door lock switch, S2 is in the AUTO position. 2.If the electric strike, M2538 is in the release position, do this step: Do this task: Door Does Not Lock in the AUTO Position - Fault Isolation, 52-50 TASK 804. 3.If the electric strike, M2538 is in the engage position, do these steps: (a) Install a new control panel switch/light module, P8-47. These are the tasks: Cockpit Control Panel Switch/Light (P8-47) Removal, AMM TASK 52-51-07-020-801, Cockpit Control Panel Switch/Light (P8-47) Installation, AMM TASK 52-51-07-420-801. (b) If the LOCK FAIL light went out with the door lock control switch in the AUTO position, you have corrected the problem.  (c) If the LOCK FAIL light did not go out with the door lock control switch in the AUTO position, continue: (d) Install a new chime module, M2537. To install a new chime module. These are the tasks: Chime Module Removal, AMM TASK 52-51-06-000-801, Chime Module Installation, AMM TASK 52-51