基于disc方法的翼型反设计软件开发-流体力学专业论文.docxVIP

雌班工业戈学硕士学位论文 雌班工业戈学硕士学位论文 辅 要 摘要 本论文采用焱接表蕊曲率迭代方法(DISC)进行跨声速翼型设计。本文的 设计方法与正计算过程肖相对的独立性，可分别和不同的流场分析程序耦合， 形成翼型设计软{串。 反设计方法的难点在于如何确定目标压力分布。本文根据总体设计参数 用一系列控铡点米生成强标压力努鑫，在设计避程中这黪控制点豹垃鹫拳l大 小可以遁当调节以满足流动和形状约束。尽管本文采用DISC方法进行设计， 锤只要楚使用豢定麴匪力分毒终必曩搽暴力分露豹竣诗方法都霹以采嗣本文 的目标压力分布生成与修改程序。 葵铡设计结聚表明，最终设谴’冀鳌豹滚动参数秘形浚参数罄缀接_i纛要求 的值。因此，本文的DISC设计法为气动力设计提供了 个行之有效的方法。 DISC设蟊’法楚一个不鼗迭代豹遘稷，参数逡取颓琰，零j蠲图形久橇嗣户 界面可减轻工作量。本文讨论了具体的软件实现方法，并介绍了使用筒向对 象方法镧作界瑟静原理。本软{警其有友好靛搡佟赛面，使用方便并量．司‘露。 关键词：翼型设计 表丽曲率迭代法 欧拉方程 压力分椎 图形人机用户界面 面向对琢程序设计 西北工业大擘硕士学位论文 西北工业大擘硕士学位论文 ABSTRACT Abstract In this paper the Direct Iterative Surface Curvature(DISC)design method is presented for designing airfoils at transonic speeds．The design method used here is relatively independent with the direct procedure of calculation of flow solver by finite volume method，other flow solvers can also be easily coupled with this design method． The difficulty of inverse design method is how to develop the target pressure distribution．In this approach，an target pressure distribution is developed using a set of control point and require only global parameters as input．The chordwise locations and pressures of these points are then aptly adjusted during process to satisfy the flow and geometric constraints．Although the DISC design method was used in this study,the target generation and modification procedures can be used with any design method that uses a specified pressure distribution as its objective． The results of test cases indicate that the flow parameters for the final design met the requirements and that the geometric parameters were fairly close to the desired values．Thus，the DISC design method offers an efficient approach to aerodynamic design． DISC design method is an iterative process．Because of complexity of determining parameters，SO it Can reduce the workload using graphic user interface A software approach to accomplish the procedure is discussed in this thesis，a