开关电源气的基本知识介绍.pptVIP

4.2 DC Output 4.2.1 DC Voltage Regulation(輸出電壓範圍) The O/P shall remain within the regulation limits as defined in below TABLE while being subjected to: a. AC Input voltage changes from Min to Max as specified. b. Static load changes within the limits (from Min to Max) specified. c. Environmental Conditions. 輸出電壓範圍 四.電腦電源的主要電性能參數指標 4.2 DC Output 4.2.2 DC Output Power輸出功率 The SPS shall be capable of continuously supplying 200W output power under all specified conditions. 輸出功率和電流 四.電腦電源的主要電性能參數指標 4.2 DC Output 4.2.3 Efficiency滿載轉換效率 The power supply should be a minimum of 70% efficient under maximum rated load. 滿載轉換效率：要求最大功率輸出時的轉換效率應不低於70％。 4.2.4 Energy Star Efficient能源之星效率 When DC output power=15W and Fan turned off, the AC input power28W. (for example only) 4.2.5 Standby Efficiency待機效率 When in the Standby mode and the 5Vsb=0.5A, or 3.3Vsb=0.8A. 4.2.6 Remote Sensing+3.3V远程補償 The 3.3V output should have provisions for remote sensing to compensate for excessive cable drops. 四.電腦電源的主要電性能參數指標 4.2 DC Output 4.2.7 Outputs Ripple Noise(輸出紋波雜訊) Maximum allowable Peak-to-Peak ripple and noise (as measured at the load) not exceed the specified. 20MHz bandwidth oscilloscope, Resistive load(non electronic), 0.47uF//22uF(for Compaq) or 0.1uF//10uF(for Intel), Assembled in enclosure, proper connected to GND. 雖然經過了多重的濾波， 開關電源的輸出端也不可 能完全杜絕紋波，ATX標 準對電源紋波輸出的大小 作出了規定，紋波越小， 電源的品質也越好： 四.電腦電源的主要電性能參數指標 4.2 DC Output 4.2.8 Output Transient Response (Step Load) 輸出動態響應 The power supply should be stable when subjected to load transients . 4.2.9 Capacitive Load容性負載 The power supply should be able to power up and operate normally with the following capacitances simultaneously present on the DC outputs. Output Capacitive load (uF) +12V 20000 +5V 10000 +3.3V 6000 -12V 350 +5Vsb 35