基于arm的交流异步电机在线故障监控系统-电气工程专业论文.docxVIP

华北电力大学硕士学位论文 华北电力大学硕士学位论文 I I 摘 要 交流异步电机是现代社会中应用最广泛的驱动机械，定子故障和转子断条故障 在异步电机故障中所占的比例很高，因此，研制异步电机对常见故障进行在线监控， 对于避免发生重大事故，进行故障维修，都具有非常重要的意义。 随着嵌入式技术的不断成熟和发展，智能化将是电机故障诊断系统的发展方 向。本文研究了基于 ARM 的交流异步电机在线故障监控系统。通过对异步电机的 故障机理的分析，使用资源丰富的 ARM 完成定子的电流、电压信号的检测，用采 集到的数据进行计算分析，并把检测到的数值存储在大容量存储器中，采用 S3C2440 作为核心微处理器，进行了最小系统设计，以嵌入式 Linux 操作系统为平台，设计 了电流采样电路、信号调理电路、存储器电路、LCD 显示电路、CAN 接口电路等 外围电路。通过软件对采集的数据进行故障诊断，对结果进行分析，并显示故障类 型、故障部位、故障发生时间等信息显示在 LCD 上。 最后，通过实验调试进行了故障仿真的研究，实验结果验证了本文的研究设计 和系统实现的可行性，满足预期的设计要求。 关键词：ARM；异步电机；故障；在线监控 II II Abstract AC asynchronous motor is driven machinery which is widely used in the modern society, the stator fault and rotor broken bars fault of asynchronous motor fault in a high proportion, therefore, the development of asynchronous motor online monitoring of the common fault, to avoid the occurrence of major accidents, fault repair, has a very important significance. With the development of embedded technology, intelligent will be the development direction of motor fault diagnosis system. This paper studied the ARM AC asynchronous motor fault monitoring system based on. By analyzing the failure mechanism of the asynchronous motor, detection of the use of resource rich ARM current, voltage signal of the stator, the analysis of collected data, and the data storage detected in large capacity memory, using S3C2440 as the core microprocessor, the system design, based on embedded Linux operating system as the platform, the design of the current sampling circuit, signal conditioning circuit, memory circuit, LCD display circuit, CAN interface circuit. Through the software of fault diagnosis of the collected data, analyzed the results, and display the fault types, fault location, fault time information is displayed on the LCD. Finally, through experiments to research the fault simulation, the experimental results verify the feasibility of this system design and implementation to meet the expected design requirements. keywords: ARM; asy