梁端加盖板节点域箱形加强式工字形柱弱轴连接边框架节点滞回性能的有限元分析.pdf

Abstract As a new connection form, box strengthen-joint region of beam-column connection has shown great mechanical properties. In order to further explore its mechanical properties under cyclic loading, the paper carried on the ABAQUS finite element simulation of side frame joints under low cyclic loading. This paper focuses on the standard joint and cover-plate reinforced joint , by varyin the parameters of a series of finite element analysis and data processing, and studied the failure mechanism and key member of the nodes, the connection seam stress distribution curve, stiffness classification, stiffness and ductility of matchin and other issues, at the same time, this paper also made improvement aimin at the shortcomin of the cover-plate reinforced joint. The conclusions are as follows: 1.Standard joint and cover-plate reinforced joint can reach the characteristics of stron domain, and both were semi-rigid connection in sway frames while rigidity connection in lateral frame. Stress beam flange welds connectin alon the beam width direction showed a negative V Distribution. Cover-plate can control plastic hinge away from the domin area, and can significantly improve the initial rotational stiffness and bearin capacity of the node. In contrast, the cover-plate reinforced joint stiffness and ductility match better. 2.Under high axial compression ratio, the column flange may early buckling, and presented the tendency of stron beam-weak column, and the seismic performance of joints would be greatly degradation. Axial compression ratio should be controlled within 0.6; 3.Compared to height, thickness of skin plate has a more direct and significant impact on the mechanical properties of