基于arm的逆变变压器波形采集与等效模型的仿真研究-计算机应用技术专业论文.docxVIP

Abstract This topic originated from the project which Inner Mongolia University of Technology and Inner Mongolia Municipality Science and Technology Commission co-operation in research and development of the 300W wind-solar photovoltaic hybrid DC/AC power inverter system items, This system had already installed over a hundred sets in the solar energy and the wind energy resources is rich, but the electric power infrastructure bad area. When the development, test and analysis users feedback situation discovered that the FG-300W wind-solar photovoltaic hybrid DC/AC power inverter system also has some insufficiencies.Among them, the most outstanding scenery complementary inverter is the core component of power system - the inverter controller, with a lack of perceptual load and easy to make IGBT tube overheating and burning.After comparing a large number of experiments found that switch IGBT of inverter controller damaged and inverter transformers waveform distortion are closely related,Therefore the analysis of the waveform distortion’causes and to find solutions to improve the quality of the inverter controller is great significance. This article in experimental studys foundation, has carried on the thorough analysis to the contravariant transformer parameter and the waveforms relations. Major research work includes three aspects: The design has realized the data acquisition system based on ARM core of S3C44BOX.The design hardware circuit has provided the good data acquisition, the transmission, the CRT display, under this hardware environment, has completed the corresponding software design using the ADS1.2 integration development kit.This work for the deep research inversion transformers waveform distortion question, has supplied the complete data message, simultaneously this data acquisition system also has the storage oscilloscope major function. In the pre-simulation experiment studies in the foundation, tries another method, embarks from the inverter transforme