考虑应变软化的锚板承载力大变形有限元分析-水工结构工程专业论文.docxVIP

优秀毕业论文 精品参考文献资料 Large Large deformation finite element analysis of bearing capacity of anchor plate considering strain softening Abs仃act Most of the research results about the beating capacity coefficient of anchor plate have not considered the strain softening of soil．In practical engineering，the anchor plate foundation is not only subjected to static loads，but also to cyclic loads such as wind，waves and current．Under cyclic loading，the plastic strain of the soil will accumulated and strain soflening is produced，leading to the decrease of the bearing capacity of anchor plate．In the process of rotation and adjustment of anchor plate，strain softening will occur on the soil around anchor plate because it undergo great deformation．After the rotation and adjustment of an6hor plate，the reduction of the bearing capacity of it is a problem worthy of further research．The offshore platform is generally anchored by multiple anchor plates·when an anchor D1ate is unstable to be pullout for some distance(strain softening will occur in the soil around anchor)，the bearing capacity of anchor plate in this condition is of great significance to evaluate the stability of the whole offshore platform．The influence of strain softening on the bearing capacity of anchor plate is accompanied in many engmeenng problems·bo， further research on the bearing capacity coefficient of the anchor plate considering strain softening is required． Firstly，the T．bar bearing capacity coefficients without considering strain softening was calculated bv CEL(Coupled Eulerian—Lagrangian)，a large deformation finite element method· The results by CEL are in good agreement with the results of existing plastic theoretical solutions and RITSS(remeshing and interpolation with small strain，in which the large defomlation finite element analysis is realized by remeshing technique and stress interp01ation technique Oil the basis of small deformation finite element)．So，the reliability of 也e CEL calculation model is ve