刘 英文习题稿(改）.docVIP

PAGE PAGE 3 EXERCISES 练习 CONTENTS 内容 Chapter 1 Fundamental Principles of Machine Design 章节1 机械设计的基本原则 Chapter 2 Fundamentals of Transmission Design 章节2 传动装置设计基础 Chapter 3 Flexible Transmissions 章节3 柔性传动 Chapter 4 Gear Transmission 章节4 齿轮传动 Chapter 5 Worm Gear Transmission 章节5 涡轮传动 Chapter 6 Shafting 章节6 轴系 Chapter 7 Ball and Roller Bearings 章节7 球和滚子轴承 Chapter 8 Slid Bearings 章节8 滑动轴承 Chapter 9 Bolt Connections and Screw 章节9 螺栓连接和螺丝 Chapter 10 Springs 章节10 弹簧 Chapter 11 Mechanical Construction Design 章节11 机械结构设计 Chapter 1 Fundamental Principles of Machine Design 章节1 机械设计的基本原则 EX.1.1 After being drawn up snug , in Fig.1-1, the nut M20 is given 120? additional turn. Find the force in the pipe and the bolt. The bolt is made of steel and the pipe is made of brass .Out diameter of the pipe is 32mm and internal diameter is 22mm, length of the pipe is 200 mm. EX.1.2 If the thickness of the link is 35mm.,F=30kN. Determine the width b of the offset link of Fig.1-2,if the permissible value of the working stress is 68MPa. Fig.1-1 Fig.1-2 EX.1.3 A uniform bar in tension if F=5000N,F=2000N.Material of the bar is Q235. Take the factor of safety S=1.6,based on the yield point, find the diameter of the bar. The bar has a machined surface, calculate the factor of safety for infinite life. EX.1.4 Suppose the life Nof the part under heavy test load is 20hr. The life Nunder combined loading was 32hr, of which 14hr was at the normal load and 18hr was at the heavy test load. Find the expected life Nunder the normal operating load. EX.1.5 In Fig.1-3,the leaf spring is straight and unstressed when the cam and shaft are removed. The material of the spring is 65Mn.Not any stress concentration. Spring surfaces are ground. If the cam rotates continuously, find the safe factor for the leaf spring. Thickness of the spring is ?=3mm and width b=25mm.