诺西G互操作.pptVIP

Date Presentation / Author NSN 2G-3G互操作 GSM – WCDMA 互操作 3G/2G 互操作的实现方法 GSM系统升级 升级要求 In Idle Mode Normally cell re-selection is done to cell having better coverage. Both quality (CPICH Ec/No) and rxlevel (CPICH RSCP) should be good enough in the neighbour cell before cell re-selection can happen Signal quality level requirements are checked with S-criteria Cell Ranking with R-criteria is done to select the best cell from all cells fulfilling S-criteria, Cell selection: S准则 Cell selection: S准则 Cell selection: S准则 Cell Re-selection: R准则 Cell Reselection 3G - 2G Procedure Cell Re-selection: R准则 Serving cell parameters Sintrasearch, Sintersearch and SsearchRAT (Intra-, Inter-frequency, Inter-RAT Measurement Thresholds respectively) are compared with Squal (CPICH Ec/No - Qqualmin) in S-criteria for cell re-selection. UE will measure neighbour cells depending on how the measurement threshold parameters are set sent (if parameters are not sent, UE shall measure all cells) 1 None (Squal Sintrasearch ) – UE need not perform intra-frequency measurements. 2 WCDMA intra-frequency (Sintersearch Squal ? Sintrasearch) 3 WCDMA intra- and inter- frequency, no inter-RAT cells (SsearchRAT Squal ? Sintersearch) 4 WCDMA intra- and inter-frequency and inter-RAT cells (Squal ? SsearchRAT ) WCDMA to WCDMA Cell Re-selection WCDMA to GSM Cell Re-selection NSN Strategy: reselect to GSM early Idle Mode Cell Reselection Parameter WCEL: Qhyst1 (Qhyst2) Qhyst1 is used for TDD and GSM cells, and for FDD cells when cell selection and re-selection quality measure is set to CPICH RSCP (CPICH Ec/No) (Qhyst1s/ Qhyst2s). This parameter is part of SIB 3.[0 ... 40] dB, step 2 dB, default: 4 dB. HOPS: AdjsQoffset1 (AdjsQoffset2) This parameter is used in the cell re-selection and ranking between WCDMA cells. The value of this parameter is subtracted from the measured CPICH RSCP (CPICH Ec/No) of the intra-frequency neighbour cell before the UE compares the quality measure with the cell re-selec