能量双向流动的蓄电池充放电系统研究-控制科学与工程专业论文.docxVIP

优秀毕业论文 精品参考文献资料 路中关键元器件参数。利用CCS 路中关键元器件参数。利用CCS软件编写了软件程序，实现了各控制算法， 结合系统硬件电路搭建了实验平台。 (4)仿真与实验测试 利用PLECS仿真软件搭建了系统前后两级变换器的模型，分别对设计 的控制算法做了仿真，验证了核心控制算法的正确性。利用搭建的实验平台 进行实验测试，仿真和试验结果均表明：系统无论在充电还是放电时均可以 保证其交流侧电流功率因数为O．97(放电时为．0．97)，而且交流侧电流为正 弦波，其电流THD5％，减小了对电网造成的谐波和无功污染；在放电时， 可以将蓄电池中的电能回馈到电网，节约能源。对于储能电站而言，实现了 充放电一体化，不再需要两套装置，节约了成本。 关键词：充放电，能量双向流动，PWM整流器，Buck—Boost变换器，功率 因数 万方数据 RESEARCH RESEARCH oN CHARGING AND DISCHARGING SYSTEM WITH BIDIRECTIoNAL ENERGY FLoW FoR BATTERY ABSTRACT With the aggravation of energy and environmental problems，the application of energy storage station，electric vehicle and new energy has gradually increased．Currently,batteries are also in wide used．In the process of using a battery,large number of battery charging devices are required．Several charge—discharge tests are usually carried out on the battery before use．Therefore， a battery charging and discharging device which has high performance and does not pollute the power酣d is required．At present，the most widely used high power battery charging device is realized by a phase control rectification of thyristors．In this kind of device，the current waveform distortion in ac side is obvious，the power factor is low,and the pollution of power grid is much．It has other disadvantages such as low automation，complex operation，and poor reliability．It also breaks down easily．In addition，the discharging device consumes electric energy in the form of thermal energy due to resistances in the power conversion device．This causes a great waste of energy．According to the existing problems of battery charging and discharging device，a bakery charging and discharging system with bidirectional energy flow is studied in this thesis． The main work of this thesis Can be summarized as the following： (1)Selection of topological structure and research of control strategy for the system The topological structure of the charging and discharging device with bidirectional energy flow is studied．The pre—stage adopts a three—phas