工频滤波器的应用仿真.doc

基于工频滤波的线路绝缘及定相测试仿真 邢华栋，刘锋，张爱军 （内蒙古电力科学研究院，呼和浩特 010020） 摘要：架空输电线路多回、交叉跨越等情况将导致临近线路产生感应电压，同塔架设的输电线路感应电压甚至高达上千伏，若用兆欧表对其进行绝缘及定相测试，则设备存在被烧毁的风险。本文基于RC分压原理设计了一种工频滤波器，将其装到兆欧表和被测线路之间，能够有效降低兆欧表承受的工频感应电压，同时装置的引入对线路绝缘及定相测试结果无影响。用PSCAD对工频滤波器、兆欧表和同塔双回输电线路进行建模，通过系统仿真得出工频滤波器参数的合理范围。仿真结果表明将工频滤波器用于输电线路绝缘及定相测试可以有效保护兆欧表，而且测试结果不受影响，是一种简单可行的方法。 关键词：工频滤波器；兆欧表；绝缘测试；定相测试；感应电压；输电线路 中图分类号：TM930.1 文献标识码：B 文章编号：1001-1390(2017)00-0000-00 Simulation of line insulation and phasing tests based on power frequency filtering Xing Huadong, Liu Feng, Zhang Aijun (Inner Mongolia Electric Power Research Institute,HohhotInstitute, Hohhot 0l0020, China) Abstract：MultipleAbstract: Multiple transmission lines or crossing transmission lines would lead to the induced voltage in adjacent lines. The Induced induced voltage of transmission lines on the same tower even reach reaches up to thousands of volts. Thus, if a megger is directly used to test insulation and identify phase of a transmission line, there exists high risk for the megger. In this paper, a kind of power frequency filter is designed based on a RC divider. It can effectively reduce power frequency induced voltage to the level that the megger can bear by installing the device between a megger and a tested line. The usage of the device does not have any effect on the results of insulation and phasing tests. Models of megger, power frequency filter and high-voltage double-circuit transmission lines on the same tower were built with PSCAD. The reasonable power frequency filter parameters wererange of power frequency filter parameters was optimized by system simulation. According to tThe simulation results, show that it is a simple and feasible method to apply power frequency filter to the insulation and phasing tests of transmission lines, by which megger would be out of the damage of induced voltage and the test results would not be influenced as well. Keywords： : power frequency filter, megger, insulation test, phasing test