齿座冲压工艺分析及模具设计.docVIP

齿座冲压工艺分析及模具设计 摘 要 本论文对齿座进行了冲压模具设计。根据对齿座冲压工艺的分析比较，拟定了二套齿座的加工工艺方案，并进行了优化分析，确定了先落料冲孔在弯曲成形的工艺方案。本设计主要内容：根据对齿座零件冲裁件的分析选取合适的排样；根据工艺分析确定模具的选取那种复合模具结构；根据对工件所受冲裁力、顶件力、卸料力的计算，确定总的冲压力；根据计算确定工件压力中心；根据冲裁件设计工艺零件和选择合适结构零件；最后选取合适的压力机。 本论文阐述了落料冲孔倒装复合模具的结构设计及工作原理。该套模具的优点冲孔废料能直接从凸凹模内落下，而冲裁件能被推件板从落料凹模推下，采用弹性卸料装置结构简单节省成本，生产率高等。 关键词：冲压，复合模具，落料，冲孔 THE STAMPING PROCESS ANALYSIS AND DIE DESIGN FOR GEAR HOLDER ABSTRACT In this thesis, the gear holder was stamping die design. According to the gear holder stamping process analysis and comparison, developed two sets of gear holder processing programs, and optimized analysis to determine the first blanking punching in the bending process scheme. Design of the main content: Based on the gear seat parts blanking analysis to select the appropriate nesting; according to the technical analysis to determine the selection of the kind of complex mold structure; suffered under blanking force on the work piece, the top member force, unloading force calculations to determine the type of machine; according to the calculation to determine the work piece center of pressure; design process based on blanking parts and select the appropriate structural parts. This paper describes the flip composite blanking punching mold design and working principle. The advantages of this mold punching waste can be directly from the punch and die within the falling, blanking option board can be pushed from the blanking die and easier to push the lead to go down with flexible unloading device structure is simple cost savings and high productivity. KEY WORDS: stamping，composite mold，blanking，punching 目　录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc359492715 前　言 PAGEREF _Toc359492715 \h 1 HYPERLINK \l _Toc359492716 第1章 概 论 PAGEREF _Toc359492716 \h 3 HYPERLINK \l _Toc359492717 1.1课题的任务 PAGEREF _Toc359492717 \h 3 HYPERLINK \l _Toc359492718 1.2国内外现状及发展趋势 PAGEREF _Toc359492718 \h 3 HYPERLINK \l _Toc359492719 1.2.1 国内外现状 PAGEREF _Toc359492719 \h 3 HYPERLINK \l _Toc359492720