思科认证mod碎ule7.pptVIP

Slide 2 of 2 Purpose: Layer 2—Adds the access-group command for IP. Emphasize: The list number must match the number (100 to 199) you specified in the access-list command. Slide 1 of 3 Purpose: This 3 layers slide shows an example of an extended IP access list. Emphasize: Slide 2 of 3 Purpose: Emphasize:. Don’t forget to include the permit statement to permit all other IP traffic out on E0. Slide 3 of 3 Purpose: Emphasize: Slide 1 of 3 Purpose: This slide gives another example of an extended IP access list configuration. Emphasize: Notice this example of an IP extended access list specifies a source subnet address and any destination address. Slide 2 of 3 Purpose: Emphasize: Don’t forget to include the permit statement to permit all other IP traffic out on E0. Slide 3 of 3 Purpose: Emphasize: Slide 1 of 1 Purpose: This slide shows how to verify an access list. Emphasize: Lists IP interface information. Indicates whether outgoing access list is set. Review the output of the show ip interface command. The highlighted text shows details about access list settings in the show command output. Slide 1 of 1 Purpose: This slide introduces the show access-lists command used to verify access lists. Emphasize: This is the most consolidated method for seeing several access lists. Note, the implicit deny all statement is not displayed unless it is explicitly entered in the access-list. Slide 3 of 3 Purpose: Emphasize: Shows a deny result of the access list test. Now the packet is discarded into the packet discard bucket. The unwanted packet has been denied access to the outbound interface. The Notify Sender message shows a process like ICMP, returning an “administratively prohibited” message back to the sender. Slide 1 of 4 Purpose: Emphasize: This graphic explains in more detail the processes access list statements perform. Use the graphic’s diamond expanded from an earlier page to show individual access lis